Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CGI Driveway & Pavers: The Dallas Owner’s Guide
We install CGI-compatible driveway and paver systems across Dallas, with paver driveway installation typically running $7,000 – $18,000 and concrete driveway installation at $4,500 – $12,000 depending on square footage, base prep, and the paver series you choose. Most jobs are planned around a single-visit install once materials are staged. Groundwork Construction Co. of Dallas is an independent service provider and is not affiliated with CGI.

Owners usually discover the problem the same way: a hairline crack that spreads after a freeze, a paver that rocks underfoot near the garage apron, or a section of driveway that holds water after every Dallas rain instead of draining to the street. Sometimes it’s a color lot that no longer matches the rest of the field, or edge restraint that has lifted and let the field spread. Whatever the symptom, it points to one of a few failure points: base compaction, joint sand loss, drainage slope, or a paver batch that wasn’t spec-matched to your CGI series. We see all of them on Dallas driveways, often after a summer of expansive clay soil movement followed by a wet fall.
Which CGI Models This Applies To
CGI paver systems are sold in series lines, and the details that matter for a replacement are the paver dimensions, the thickness class, and the color lot. Most residential driveways in Dallas use a 60mm or 80mm thickness paver; going thinner on a driveway is where we see early failures. Before we quote, we identify your existing paver by measuring face dimensions and thickness on site. Some owners have the original spec sheet or an invoice from the installer, which saves time. If not, we measure and match.
Here’s the compatibility gotcha most homeowners don’t know: even within the same CGI series, color lots shift between production runs. A “matching” paver ordered years later can read visibly different in overcast light or after rain. We always recommend pulling a field paver from an inconspicuous spot to compare against new stock before ordering, and where a full match isn’t possible, planning the layout so the color shift lands where it reads as intentional. On the OEM-vs-aftermarket decision, we source CGI-spec-compatible pavers rather than pushing a substitute, but we’ll tell you plainly when a quality equivalent makes more sense for budget or availability. We don’t stock pavers locally and don’t carry them on a truck; materials are ordered to spec for your job.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CGI Driveway & Pavers Is Failing
- Pavers rocking or shifting underfoot. Base compaction has failed or joint sand has washed out, letting the field move independently. Common on Dallas driveways where clay soil swells and shrinks with our wet-dry cycles.
- Standing water after rain. The driveway slope has settled or was pitched wrong at install, so water pools instead of running to the street or a drainage channel. Left alone, it works into the joints and accelerates base failure.
- Joint sand eroding between pavers. Rain, irrigation overspray, and foot traffic strip sand over time, opening gaps that let weeds in and moisture down. In Dallas, a joint sand refresh every few years is normal maintenance, not a defect.
- Edge restraint lifting or separating. The border that holds the field tight has pulled loose, letting pavers spread outward. Once the edge fails, the whole field loses its interlock.
- Color mismatch or visible patching. A section repaired with a different batch or a different CGI series reads as a patch job. This is the one that bothers owners most, because it’s cosmetic but permanent unless the field is redone properly.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Dallas, paver driveway installation runs $7,000 – $18,000. Concrete driveway installation runs $4,500 – $12,000. Driveway replacement typically runs $5,000 – $14,000, and paver patio installation runs $3,500 – $11,000 if you’re doing the drive and patio together. Driveway sealing runs $250 – $700 as a standalone service.
What drives the range: square footage, whether we’re tearing out and hauling off existing material, base depth and compaction, drainage correction, and the CGI series you choose. Every quote is line-item: excavation, base, edge restraint, pavers, joint sand, and cleanup are broken out so you can see where the money goes. The number you see is the number you pay. Upfront pricing, no surprises. All work is covered by the 730-Day Done Right Promise; if it’s not done right, we make it right.
DIY or Call Us?
You can safely check a few things yourself. Measure your paver thickness and face dimensions and write them down. Walk the driveway and mark every rocking paver with chalk. Note where water pools after rain. If you have the original spec sheet or installer invoice, pull it.
Where DIY goes wrong on pavers: base compaction. A driveway needs the base compacted in lifts to spec, not dumped and raked. Getting that wrong means the new pavers fail the same way the old ones did, usually within a season or two. Setting edge restraint properly and cutting the final course to fit are also where untrained installs show. Pavers aren’t dangerous to handle, but a driveway is an investment and a bad base wastes it. Call (844) 797-4808 to schedule your free estimate; we answer with a live person, 24/7.
FAQs
A well-installed CGI paver driveway in Dallas typically lasts 25 – 30 years or more, with the pavers themselves often outlasting the base. The failure point is almost never the paver; it’s the base, the edge restraint, or joint sand maintenance. Call (844) 797-4808 for an exact quote on your driveway – estimates are free.
Yes, in many cases. If the failure is localized, like a settled section near the garage apron or a lifted edge restraint, we can lift the affected pavers, correct the base, and reset them. Full replacement makes more sense when the base has failed broadly or the slope is wrong throughout. We’ll tell you honestly which one you’re looking at. Call (844) 797-4808 for a free estimate.
Most residential paver driveways take 2 – 4 days once materials are on site, depending on square footage and base conditions. Teardown and haul-off add time if we’re removing an existing driveway. We schedule around Dallas weather since rain can pause base work. Call (844) 797-4808 for a free estimate and a realistic timeline.
We source to your existing paver’s spec: thickness class, face dimensions, and a comparison of color lot against a field sample pulled from your driveway. We order materials to spec for your job and don’t carry stock on a truck or in a local yard. If a true match isn’t available, we’ll show you the alternatives honestly before you commit. Call (844) 797-4808 for a free estimate.
If your Dallas driveway is showing any of these signs, the worst move is waiting through another Texas freeze-thaw cycle with a failing base. We install CGI-compatible driveway and paver systems across Dallas, backed by upfront pricing, no-hassle financing at 0% for 18 months, $1,000 off projects over $10,000, and background-checked, uniformed technicians on every job. We also work with KraftMaid, Cambria, and Silestone on interior projects if you’re planning more than the driveway. From foundation to finish line, one contractor handles it. Call Groundwork Construction Co. of Dallas at (844) 797-4808 for your free estimate.
Written by the team at Groundwork Construction Co. of Dallas, serving Dallas and nearby areas.