Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ES Windows Kitchen Remodeling: The Dallas Owner’s Guide
Kitchen remodeling built around ES Windows products in Dallas typically runs $14,000 to $45,000 installed, depending on whether you’re refreshing cabinets and counters or taking the room down to the studs. That figure covers labor, materials, permits, and disposal, not just the window units themselves. Planned remodel work is scheduled, never rushed, so expect a start date within a few weeks rather than a same-day crew. We’re an independent contractor and not affiliated with ES Windows, but our technicians have up to 12 years of experience working with these products in Dallas homes.

Owners usually discover a problem in stages. It starts with a window that won’t lock or a sill that’s soft to the touch. Then a cabinet run beside an ES Windows unit starts separating, or a countertop edge pulls away because the wall behind it shifted. In older Dallas homes, we routinely see the pairing of aluminum-frame ES Windows units and 1990s-era particleboard cabinets fail together during humid summers, because neither material tolerates swings in moisture well. By the time you notice, the remodel question is already on the table.
Key Takeaways
- Installed kitchen remodel in Dallas: $14,000 – $45,000; smaller kitchens land $9,000 – $20,000.
- ES Windows units are frequently paired with KraftMaid, Cambria, and Silestone finishes we also install and service.
- The most common failure is water intrusion at the window opening, not the window glass itself.
- We’re an independent provider, not affiliated with ES Windows.
- Every project carries our 730-Day Done Right Promise.
Which ES Windows Models This Applies To
ES Windows has produced several lines over the decades, and the specific model matters less than the way it was installed. That’s because kitchen remodeling work around an existing ES Windows opening depends on rough opening dimensions, sill height, and how the original installer flashed and sealed the frame. Before we quote anything, we pull the label from the window sash (usually a small sticker in the jamb channel or the upper corner of the frame), measure the rough opening ourselves, and match it to the correct replacement or extension component.
When we look at OEM versus aftermarket for ES Windows products specifically, the decision comes down to availability and fit. Genuine ES Windows parts guarantee a drop-in match, but lead times and cost can run noticeably higher than a quality aftermarket equivalent that’s dimensionally identical. For most Dallas homeowners, a verified aftermarket match makes more sense on a remodel where the window opening is being reworked anyway. Where exact geometry has to be preserved, we recommend OEM. We’ll show you both paths in writing, side by side, before you commit to either.
One compatibility gotcha worth flagging: several ES Windows lines used slightly different sill angles between production runs. If you order a replacement component without confirming the run, it can seat against the rough sill with a gap that only shows up after the first hard Dallas rain. That’s a part-match problem, not a window problem.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ES Windows Kitchen Remodeling Is Failing
- Window won’t latch or drift-closes on its own. The sash or hinge hardware has worn past tolerance, and the frame may have racked. When it happens next to a cabinet run, suspect wall movement tied to water intrusion.
- Soft or discolored sill inside the kitchen. Moisture has worked behind the drywall and into the framing. This is the failure mode we see most in Dallas, especially on south-facing ES Windows units that take afternoon sun and summer storm-driven rain.
- Condensation between the panes. The seal on the insulated glass unit has failed. It’s a straightforward replacement if caught early; left alone, it can fog the whole assembly and eventually compromise the frame.
- Cabinets separating from the wall near the window. Often the rough opening was never properly shimmed or sealed, and the adjacent cabinet run is reacting to that movement. Cosmetic patching won’t fix the cause.
- Draft or visible daylight at the frame. Weatherstripping or flashing has failed, and the seal is compromised. In Dallas, this also lets in heat and humidity that damage surrounding finishes quickly.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Dallas, here’s what the line items look like on paper. These are installed ranges, labor and materials together, so there’s no mystery second invoice later.
| Work | Installed Range (Dallas) |
|---|---|
| Full kitchen remodel | $14,000 – $45,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
What moves you up or down the range: whether the window opening needs reframing, cabinet grade, counter surface (Cambria and Silestone sit at different price tiers), and whether plumbing or electrical has to be relocated. Every project is covered by the 730-Day Done Right Promise. Upfront pricing means the number you see is the number you pay.
DIY or Call Us?
Some checks are safe to do yourself: pull the window label, photograph the jamb and sill, measure the rough opening, and note any soft spots or daylight gaps. Stop there. The moment the work involves prying off interior trim, cutting into framing, or reframing the rough opening, it’s a different job than a homeowner should take on, and mistakes at the window opening lead directly to the water damage we see most often in Dallas kitchens. We’ll come out, measure accurately, and tell you straight whether you need a repair or a full remodel. Call (844) 797-4808 to schedule your free estimate.
FAQs
Most ES Windows units in this climate last 15 to 25 years with proper flashing and sealing, though Dallas humidity and storm-driven rain shorten the low end of that range if the sill was never sealed correctly. We can assess yours on-site and tell you whether it’s worth replacing or keeping. Call (844) 797-4808 for an exact quote; estimates are free.
Often yes, if the failure is limited to glass seal, hardware, or weatherstripping, since a repair usually costs a fraction of a full replacement. If the sill or frame has taken on water damage, repair stops making sense and we’ll tell you honestly. We give you a written line-item quote either way.
A single window repair or replacement typically runs a few hours to a day, while a full kitchen remodel with ES Windows integration runs one to three weeks depending on scope. We schedule the work and confirm a start date with you, so there’s no vague “sometime next month” for a project this size. Call (844) 797-4808 to get a scope and timeline for your kitchen.
We pull the model from your window label, confirm the production run, and source the exact-match OEM or a verified aftermarket equivalent, whichever fits your budget and timeline. You’ll see both options and price on the written quote before you decide. Call (844) 797-4808 to schedule your free estimate.
Written by the team at Groundwork Construction Co. of Dallas, serving Dallas and nearby areas.