Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Unilock Driveway & Pavers: The Dallas Owner’s Guide
We install Unilock driveway pavers across Dallas, and a full paver driveway typically runs $7,000 to $18,000 installed, depending on square footage, base prep, and border detailing. Unilock pavers are a system, not a single part, so the “failure” owners call us about is usually one of five things: settled or heaved field pavers, joint sand washing out, chips at the edge course, sealer peeling, or a poly sand joint that has gone soft. We’re an independent installer, not affiliated with Unilock, and we work with the product every week.

Which Unilock Models This Applies To
Unilock makes pavers in several distinct lines, and the one on your driveway changes how we repair it. The common residential profiles in Dallas are Brussels Block (a tumbled, thicker block), Beacon Hill (a flagstone-look slab), and the larger-format Estate Wall and Thornbury lines used on drive aprons and borders. Compatibility starts with identification. Pull a loose or damaged paver from an inconspicuous spot and measure it: most Unilock driveway units run 2 3/8 inches thick for vehicular use, and anything thinner is likely a patio product that shouldn’t be under a car. The color and texture family also has to match, because Unilock runs dye lots and a 2026 replacement paver won’t always match a 2012 install. Where we can’t source an exact current-match paver, we lift pavers from a low-visibility area (behind a gate, under a hose bib) and rotate them into the damaged zone. That’s the honest OEM-versus-aftermarket call on a paver system.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Unilock Driveway & Pavers Is Failing
- Pavers rocking or sinking in a wheel path. That’s base failure, not paver failure – the compacted aggregate underneath lost its density, often because the original base wasn’t deep enough for Dallas’s shrink-swell clay.
- Joint sand washing out after storms. North Texas downpours scour polymeric sand from the joints when the sand was installed wet or the joint width wasn’t consistent.
- Heaving or tenting along the edge course. Clay soil expanding against a shallow edge restraint pushes pavers up; a proper edge restraint set in concrete holds the field in place.
- Chipped corners and spalled faces. Unilock pavers are dense, but freeze-thaw cycles in a Dallas January combined with a paver laid over a void will crack over time.
- Sealer peeling or hazing. A solvent-based sealer applied over a damp surface traps moisture and peels in sheets; the fix is stripping, not another coat on top.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what paver repair and replacement runs in Dallas, line-itemed so you can see the parts-and-labor split:
| Scope | Typical Installed Range |
|---|---|
| Full paver driveway installation (Unilock-compatible) | $7,000 – $18,000 |
| Driveway replacement (tear out and reinstall) | $5,000 – $14,000 |
| Sectional paver repair (settled or damaged field) | Quoted per square footage |
| Re-sanding / polymeric joint sand | Included in most repair scopes |
| Sealing | $250 – $700 |
What drives the range on a Dallas driveway: square footage, whether we need to remove and rebuild the base, and edge-restraint condition. Our pricing is upfront with no change orders – the number you see is the number you pay. Every job carries our 730-Day Done Right Promise.

DIY or Call Us?
You can safely check a few things yourself. Pull one loose paver, measure its thickness, and confirm the line; sweep a hose across the surface and watch where water pools; check whether edge pavers move underfoot. What goes wrong with DIY is the base. Pavers are a thin wearing course over a compacted aggregate system, and reinstalling a paver without re-compacting the base – or hand-tamping instead of plate-compacting – means the same failure returns in a season. Dallas clay doesn’t forgive shortcuts. Call (844) 797-4808 and we’ll look at it with you; estimates are free.
FAQs
A properly installed Unilock paver driveway should hold 25 to 30 years or more in North Texas, because the pavers themselves aren’t the wear item – the base is. Poor base prep under Dallas’s expansive clay is the leading cause of early failure, which is why we always check base depth before quoting a repair. Call (844) 797-4808 for an exact quote – estimates are free.
Often, yes. Individual pavers can be lifted, the base re-compacted, and the same pavers relayed, which saves the material cost entirely. We only recommend full replacement when the base has failed across a large area or the paver line is discontinued. Call (844) 797-4808 and we’ll tell you honestly which one you need.
A sectional repair is typically a single-visit job; a full driveway replacement usually takes two to four days depending on square footage and base work. We give you the schedule in writing before we start. Call (844) 797-4808 to schedule your free estimate.
We source from Unilock and from quality compatible manufacturers, and we pull current dye-lot samples so you can see the match before we install. Where an exact match isn’t available, we rotate existing pavers into the visible area. Call (844) 797-4808, and we’ll walk you through your options.
Written by the team at Groundwork Construction Co. of Dallas, serving Dallas and nearby areas.