Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Farmers Branch, TX: What This Job Runs
Vanities, tile and fixtures in Farmers Branch typically runs $9,000 – $28,000 and takes about two to four weeks of active work, depending on how much receives new material versus how much is rebuilt behind the wall. The bulk of that money goes to the vanity and countertop, floor and wall tile, and the fixture set (faucets, drains, valves, lighting, mirror). Call (844) 797-4808 for a free on-site estimate with a written line-item quote.
How the Work Actually Goes, Start to Finish
We don’t hand you a start date and disappear. Here’s the real sequence, with what you decide and when. Our technicians have up to 12 years of experience with exactly this kind of interior finish work, and the 730-Day Done Right Promise sits behind all of it.
Day 1: Walkthrough, measurements, and the tear-out plan. We confirm what’s staying and what’s going. You’ll want to decide by this point whether the vanity footprint changes, because that single choice drives the plumbing rough-in, the tile quantity, and the electrical for lighting above the mirror. In Farmers Branch’s mid-century stock, a 1950s – 70s vanity was often 30 to 36 inches; a 60-inch double vanity needs rough-in work, not just a new cabinet dropped in the old spot.
Days 1 – 2: Demo and inspection. We pull the old vanity, tile, and fixtures and open the wall to check the valve condition and any water damage. It’s common in homes around the southern edge near Brook Hollow to find a slow leak that’s softened the subfloor or the wall behind the tile. If it’s there, we show you and price the repair before we re-close anything. No surprise add-ons.
Days 2 – 4: Rough-in and prep. New shut-off valves, drain lines if the vanity moved, and electrical for the mirror, fan, and lights. This is where the behind-the-wall work gets inspected if a permit was pulled. Prep also means floor protection, backer board, and waterproofing membrane where the shower or wet wall meets the tile.
Days 5 – 12: Tile and vanity set. Floor tile generally goes down before the vanity is set so the cabinet rests on finished surface. Wall tile and shower surrounds get floated, set, grouted, and sealed. The vanity cabinet is leveled, plumbed, and set, then the countertop is templated and installed. You’ll have picked your tile layout and grout color by day 3; the pattern (herringbone, subway, large-format) is the choice that most shifts both the labor and the final look.
Days 12 – 16: Fixtures, trim, and final walkthrough. Faucets, drains, the mirror, lighting, towel bars, and caulk get installed. We test every fixture for leaks, run the fan to confirm the vent, then walk the room with you and leave you with a punch list if anything needs a touch-up. You sign off when it’s right. The 730-Day Done Right Promise covers workmanship from there.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
Most of the choices you’ll make fall into four buckets. Here’s what each one costs you in money and maintenance, honestly.
- Vanity cabinet: A stock 36-inch vanity from a box store runs $300 – $800 installed on an existing rough-in. A semi-custom vanity (KraftMaid, for instance) sized to fit the wall runs $1,200 – $2,800 and takes longer to arrive but fits like it was built for the room. Custom cabinetry above that is usually worth it only if the plumbing is getting moved anyway.
- Countertop: Cultured marble and laminate are the budget play, $150 – $400. Quartz and granite run $500 – $1,500 for a standard vanity top and resist the water spots and heat that wear out cheaper surfaces faster. The trade-off: quartz chips at the edge if something heavy drops on it; granite doesn’t.
- Floor and wall tile: Ceramic is the cheapest at $2 – $5 per square foot installed; porcelain at $4 – $9 is the smarter choice for a wet floor because it absorbs almost no water. Natural stone at $8 – $20 needs sealing every year or two in this climate. Large-format tile (12×24 or bigger) reduces grout lines but demands a flatter floor, which matters in older Farmers Branch homes where the subfloor has moved.
- Fixtures and trim: A full Kohler set (faucet, drain, shower valve and trim) runs $400 – $1,200 for a mid-range build. Cheaper import fixtures save $200 – $500 up front but the cartridges and finishes fail faster; the valve body behind the wall is the one piece you never want to skimp on.
Homeowners often pair this work with other updates on the same trip. If the roof is also on your list, we handle Tile Roofing in Farmers Branch and Specialty Roofing in Farmers Branch, so you’re not calling three different companies for three different projects.
What Vanities, Tile & Fixtures Costs in Farmers Branch, TX
The honest answer: $9,000 – $28,000 for a full room, and $800 – $3,000 if you’re only replacing the vanity and top. Here’s how the pieces break down so you can see where your job lands.
| Line item | Typical range |
|---|---|
| Vanity installation (cabinet + top) | $800 – $3,000 |
| Floor tile (standard bath, 40 – 60 sq ft) | $1,200 – $4,500 |
| Wall and shower surround tile | $1,500 – $5,500 |
| Plumbing fixture set and valve replacement | $400 – $1,200 |
| Lighting, mirror, and electrical | $300 – $900 |
| Full vanities, tile & fixtures scope | $9,000 – $28,000 |
What pushes a job to the high end: a vanity footprint change (moving the drain and supply lines adds $600 – $1,500), ripping up a tile floor that was set on a mud bed (adds a day and dump fees), relocating the toilet, or discovering water damage behind the tile. What keeps it low: keeping the plumbing where it is, choosing porcelain over stone, and replacing the vanity without redoing the whole floor.
What’s included in our written estimate: demo, prep, materials, labor, permits where required, haul-away, and the 730-Day Done Right Promise. What isn’t: upgraded tile above the standard allowance, custom glass or mirrors, and structural changes. Those get priced separately in writing, never tacked on mid-job. Upfront pricing means the number you see is the number you pay. Call (844) 797-4808 for an exact quote; estimates are free.
See the difference
Before
After
Before
After
Before
AfterWhat Farmers Branch Homes Specifically Do to This Job
Farmers Branch is a fully built-out inner-ring suburb (ZIP 75234), which means almost nobody here is building new. Nearly every vanities, tile & fixtures job we run is a renovation of existing housing – mostly mid-century ranch homes and post-war cottages from the 1950s through the 1970s, with older stock near the Dallas line that blends into the Brook Hollow and Marsh Lane area. That build era shapes the work in concrete ways: original mud-set tile floors are harder to remove than modern thinset, the shut-off valves are often gate valves rather than quarter-turn ball valves, and electrical outlets near the vanity usually aren’t GFCI-protected until we replace them.
The city itself enforces codes tightly on older properties, so we plan for inspections rather than hoping they don’t happen. Anything that moves plumbing or adds electrical in a bathroom generally triggers a permit and an inspection. We pull it and pass it, and we tell you at the estimate whether your job will need one.
The Blackland Prairie clay under these homes also matters. It swells and shrinks hard between droughts and wet springs, and that movement shows up as cracked floor tile, doors that stick, and vanity cabinets that go out of level over the years. When we set a vanity in an older Farmers Branch home, we check and shim to the actual floor, not to spec. Cracks coming back a few months after a tile job usually mean the movement is still happening and the tile was set on a floor that wasn’t stabilized first.
If your project grows into a full Bathroom Remodeling in Farmers Branch, the tile, vanity and fixture choices carry over – same crew, same quote, no separate company to manage. We cover the whole city as part of our Farmers Branch service area, and you can see the wider scope on our Bathroom Remodeling service page.
Serving Farmers Branch, TX – Our Local Coverage Area
We serve Farmers Branch and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Vanities, Tile & Fixtures in Farmers Branch
Two to four weeks of active work for a full room, or one to three days for a vanity-only swap. The wildcard is demo: older homes here often hide a mud-bed tile floor or water damage that adds a day or two. We give you a schedule at the estimate and update you if that changes.
You need a permit if the plumbing or electrical moves, not if you’re only re-tiling and swapping a vanity in the same spot. The city permits on older properties, so we check before we start and pull it if required. We handle the inspection either way.
Yes, and it’s the most common scope we run. A same-footprint vanity, new floor and wall tile, and new fixtures stay well under $9,000 and finish in under two weeks. Moving the drain or adding electrical is what pushes a job into the higher range and adds time.
Budget $2,000 – $7,500 for a new vanity set and a tiled floor without moving plumbing. A full vanities, tile & fixtures scope with a shower surround, new fixtures, and lighting lands between $9,000 and $28,000. Call (844) 797-4808 for an exact quote – estimates are free.
Every job is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in the residential construction space. Calls are answered by a live person 24/7, and every technician is background-checked and arrives in uniform.
Get a Free Estimate on Vanities, Tile & Fixtures in Farmers Branch
Call (844) 797-4808 to schedule your free on-site estimate for vanities, tile & fixtures in Farmers Branch. A live person answers around the clock. We’ll measure the room, confirm what can stay and what has to come out, tell you whether a permit applies, and hand you a written line-item quote with a real start date. No-hassle upfront pricing, no change orders, and 0% financing for 18 months on approved projects.
Written by the team at Groundwork Construction Co.