Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Coppell, TX: What the Job Actually Involves
Replacing a bathroom vanity and re-tiling floors, walls or a shower surround in Coppell usually runs $9,000 – $28,000 for the full package: new vanity, vanity top, tile, and fixtures like faucets, shower trim, and a new toilet. Most of these jobs take two to three weeks from demo to final grout. You can skip the guesswork entirely and call (844) 797-4808 for a free written estimate. One caveat up front: if you’re adding a shower curb, moving a drain, or changing the layout, water lines and the shower pan need to be inspected before tile goes down. That inspection is what separates a bathroom that lasts 20 years from one that leaks in five.
How We Run a Vanities, Tile & Fixtures Job in Coppell, Day by Day
This isn’t a mystery when it’s laid out honestly. Here’s the real sequence, whether it’s a single-vanity swap in a 1990s brick traditional off Denton Tap or a full tile-and-fixture package in an Old Town ranch that’s been gutted back to studs.
Day 1: Demo and protection. We pull the vanity, shut off water, remove the toilet, and carefully demo the old tile, thinset and backer board down to the substrate. Floors get protected, dust barriers go up, and we haul everything out the same day. Some tile comes up clean; some needs the whole subfloor skimmed with leveling compound, which adds a day and about $500 – $1,200.
Days 2 – 3: Rough-in and inspection. If we’re moving a drain, relocating a supply line, or swapping a tub for a shower pan, plumbers and electricians do the rough work here, then the city inspector signs off before anything is covered. If you’re not changing the layout, this stage collapses to a few hours of checking existing valve condition and confirming drain height.
Days 3 – 6: Backer board and waterproofing. Cement backer or a bonded waterproofing membrane goes down, seams are taped and coated, and corners get reinforcement. This is the stage that fails silently when it’s rushed. We let waterproofing cure fully before any tile goes up.
Days 6 – 12: Tile setting. Floor and wall tile go in, set with the right mortar for the material (modified for porcelain, unmodified for stone, different for glass). Grout follows after 24 – 48 hours. If grout is scheduled too soon, it can crack along the joints within a year.
Days 12 – 15: Vanity, fixtures and final. Vanity cabinet, top, sink, mirror, faucet, toilet, shower trim. Then the punch walk: re-caulk, clean, and confirm every fixture runs without a drip. You walk it with us, and we fix anything on your list before we call it done.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Make: Vanity, Tile and Fixtures
- Vanity cabinet material: Plywood boxes hold up in North Texas humidity far better than particleboard. A solid-wood or plywood vanity with a good finish runs in the higher part of the $800 – $3,000 vanity range, but it’s the difference between 15 years and 8 in a bathroom with a shower.
- Vanity top: Cultured marble or quartz is the practical sweet spot. Granite is beautiful but needs sealing; laminate is the budget route and will show wear fast in a primary bath. Quartz is the most forgiving with Coppell’s hard water, which spots mineral-sensitive surfaces.
- Floor tile: Porcelain is the workhorse (durable, low maintenance, $4 – $12 per square foot installed for standard grades). Natural stone like travertine is stunning but requires sealing twice a year and is more prone to hairline cracking over a slab that moves.
- Wall tile: Ceramic and porcelain are straightforward; glass mosaic is the accent everyone asks for but takes longer to set and runs higher in labor per square foot.
- Fixtures: Kohler and similar mid-to-premium brands run $100 – $400 for a faucet, and the trade-off is simple: cheaper finishes pit and peel in five to seven years, quality finishes hold up much longer.
- Shower trim and valve: A pressure-balanced valve is standard; a thermostatic valve is the premium upgrade. Splurge here only if you use a lot of hot water simultaneously.
What Vanities, Tile & Fixtures Cost in Coppell, TX
The lead range for a full vanities, tile and fixtures package here is $9,000 – $28,000, and the low end is a small secondary bath with standard porcelain, a stock vanity, and minimal layout change; the high end is a primary bath with custom vanity, large-format stone, and relocated plumbing.
| Line item | Typical range |
|---|---|
| Bathroom vanity installation | $800 – $3,000 |
| Tile (floor and walls, labor + material) | $3,500 – $9,000 |
| Fixtures (faucet, trim, toilet, accessories) | $1,200 – $3,500 |
| Plumbing rough-in (if layout moves) | $800 – $2,500 |
| Demo, prep, waterproofing | $1,500 – $3,000 |
What moves you toward the top: square footage above 60 sq ft, moving the toilet or drain, tile in a natural stone or mosaic grade, and a custom or double vanity with a stone top. Also real in Coppell: slab movement. If the floor isn’t flat, we need to level it before tile, and that’s an add.
What’s in a written estimate: all labor, materials, haul-away, the waterproofing system, and the permit when one is required. What often isn’t on a competitor’s bid: subfloor prep, moving fixtures, or the cost of an inspection-driven rework. Ours are upfront: the number you see is the number you pay. No change orders, no surprises. Call (844) 797-4808 when you’re ready for a real number.
See the difference
Before
After
Before
After
Before
AfterWhat Coppell Houses Do to a Tile and Vanity Job
Most of the homes we re-tile in Coppell were built in the 1980s through the 2000s, on post-tension slabs over blackland clay. That clay moves seasonally, and it shows up in a tile job as a floor that’s slightly out of plane, hairline cracks in original grout, or a shower that’s been leaking quietly into the curb for years. The leveling step we mentioned above exists for a reason. We check for flat before we set any tile, and we use flexible underlayment or uncoupling membranes where the slab slab movement is active. The other Coppell-specific wrinkle: in the older neighborhoods around the Coppell ISD schools and Old Town, bathroom layouts were designed for modest footprints and single vanities. A 60-inch double vanity often doesn’t fit without reworking a closet wall. Newer tear-down infill homes have the opposite problem: larger baths that were finished in builder-grade materials and are ready for an upgrade the owners can actually keep.
Serving Coppell, TX – Our Local Coverage Area
We serve Coppell and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs: Vanities, Tile & Fixtures in Coppell
Most jobs take two to three weeks from demo to walk-through. Secondary baths with no layout change finish closer to 10 – 12 days; primary baths with plumbing relocation or a tricky slab run the full three weeks. The timeline is real, not a sales promise.
Cosmetic-only work like swapping a vanity or re-tiling a floor usually doesn’t. Any change to plumbing, electrical, or the shower pan, and the work falls under a permit. Because Coppell’s design and inspection standards are strict, we pull the right permit and get the inspection signed off before we cover any waterproofing. Trying to skip it just costs more later.
Yes, and that’s how most of our Coppell jobs are scoped. Same footprint, same drain location, same valve height means a much simpler job and a number closer to the $9,000 side of the range. Only relocate if the layout genuinely doesn’t work.
Expect $9,000 – $28,000 depending on bathroom size, material grade, and whether plumbing relocates. The single biggest swing is your tile choice: standard porcelain versus natural stone can move the number by several thousand dollars on its own.
Groundwork backs every vanities, tile and fixtures installation with the 730-Day Done Right Promise. If it’s not done right, we make it right, for two full years. That’s one of the longest workmanship guarantees in the residential construction space, and it’s in writing.
Get a Written Estimate for Vanities, Tile & Fixtures in Coppell
If you’re ready to price a new vanity, tile, and fixtures in Coppell, call (844) 797-4808 for a free on-site estimate. A live person answers, 24/7. We walk the bathroom, measure, talk through material options and give you a line-item number on the spot. If the project is part of a full Bathroom Remodeling in Coppell, we scope both together. We cover all of Coppell, and many of these jobs are paired with exterior work like Tile Roofing in Coppell or Specialty Roofing in Coppell. You can also review our full Bathroom Remodeling service for everything that surrounds a vanity-and-tile upgrade.
Written by the team at Groundwork Construction Co.