Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
American Standard Driveway & Pavers: The Dallas Owner’s Guide
If you’re searching for American Standard driveway and pavers service in Dallas, here’s the short version: we install, repair, and replace driveway and paver systems built to match American Standard specifications, and most paver driveway installations in Dallas run $7,000 to $18,000 installed. Concrete driveway installs fall in the $4,500 to $12,000 range, and replacement work runs $5,000 to $14,000. We’re an independent contractor and not affiliated with American Standard, so we quote real labor and material numbers rather than dealer parts catalogs.

Dallas owners usually discover a problem the same way: a driveway that held up for years starts showing popped pavers after a freeze, or a slab cracks along a root line from a live oak that has been quietly pushing underneath since the last dry summer. The pattern in North Texas is specific. We see it in Lakewood, in Preston Hollow, and out in Plano where the clay soil does the most damage. You notice a rocker first, a paver that shifts when you step on it. Then the joint sand washes out at the curb line, weeds move in, and the whole surface starts to feel loose underfoot.
Key Takeaways
- Paver driveway installation in Dallas: $7,000 – $18,000; concrete: $4,500 – $12,000; sealing: $250 – $700
- Expansive clay soil is the number one cause of driveway failure across Dallas County
- Freeze-thaw cycles in North Texas pop paver joints more than heat alone
- All work backed by our 730-Day Done Right Promise
- Calls answered by a live person, 24/7 – call (844) 797-4808
Which American Standard Models This Applies To
American Standard’s driveway and paver line covers several series, and identifying the right match comes down to three things: the paver profile, the thickness, and the base system underneath. Standard driveway pavers are typically 60mm to 80mm thick, and that thickness matters in Dallas. Anything under 60mm will not survive a loaded truck turning in a residential driveway on clay subgrade, and we’ve replaced plenty of thin-profile pavers in the Park Cities that cracked within two seasons.
The fastest way to identify what you have is to pull one paver from a corner or a low-traffic edge and measure it. Width and length nominally, thickness with a tape or caliper. If the original install used a specific American Standard series, that dimension usually matches a standard profile within a millimeter or two, which means a compatible replacement is available even if the exact colorway is discontinued.
On the OEM-versus-aftermarket question: for pavers, “OEM” mostly means a color and profile match, not a proprietary part. A quality aftermarket paver of the same dimensions and compressive strength will perform identically in a Dallas install. The decision that actually matters is base preparation, not the brand stamp on the block. For concrete driveways, the equivalent choice is mix design and reinforcement – a 3,500 to 4,000 PSI mix with rebar or mesh, poured over a properly compacted base.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your American Standard Driveway & Pavers Is Failing
Here’s what actually goes wrong, and why. Each of these symptoms points to a specific cause you can confirm before you spend a dollar.
- Popped or lifted pavers after a freeze. Water gets into the joint sand, freezes, and expands. Dallas gets just enough hard freeze nights each winter to do this repeatedly, and each cycle widens the gap.
- Rutting or depressions in the wheel path. The base layer was under-compacted or too thin for the soil. On North Texas clay, a 4-inch base is a common shortcut that fails within a few years under daily traffic.
- Weeds and joint sand loss. The polymeric or joint sand has washed out and the paving surface is no longer locked. Left alone, this lets water reach the base and accelerates everything else on this list.
- Slab cracks in a concrete driveway. Usually a root from a mature tree, or a pour without proper control joints. Cracks wider than a quarter inch are a structural warning, not a cosmetic one.
- Standing water at the garage apron. Poor grading or a settled slab, and the consequence is water pushing toward your foundation. In Dallas, that becomes a foundation problem within a few years if ignored.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed pricing in Dallas depends on square footage, base condition, and paver selection. Here’s what we quote, and these ranges hold across the metro:
- Paver driveway installation: $7,000 – $18,000
- Concrete driveway installation: $4,500 – $12,000
- Asphalt driveway paving: $3,500 – $9,000
- Driveway replacement: $5,000 – $14,000
- Driveway sealing: $250 – $700
- Paver patio installation: $3,500 – $11,000
What drives the range: total square footage, whether the old surface needs full removal, the depth of base repair required, and whether drainage corrections are needed. A sealing job is a modest line item. A full replacement over failed clay subgrade is at the top of the range, and honestly should be. Every quote is upfront pricing, no surprises – the number you see is the number you pay. All work is covered by our 730-Day Done Right Promise, and we pull the permits Dallas requires for driveway work and pass the inspections.

Most driveway projects are not a single-visit job. Removal, base prep, and installation of a paver or concrete driveway typically run several days depending on size and site access, and we’ll give you a realistic schedule in writing before work starts.
DIY or Call Us?
Owners can safely inspect their own driveway, and should. Check for rockers by stepping across the surface, hose it down and watch where water pools, look for cracks wider than a quarter inch, and probe a soft joint with a screwdriver to see how much sand is gone. That’s information, not repair.
Where DIY goes wrong: re-sanding a joint that has lost its base, or topping a failing slab with a skim coat. Neither holds, and both make the eventual repair cost more because we’re now removing a failed layer. There’s no genuine safety danger in driveway work the way there is with electrical or elevated roofing, but there is a real risk of spending money on a fix that won’t last a Dallas summer. Call (844) 797-4808 and we’ll tell you honestly whether you need a repair or a replacement, and what it will cost.
FAQs
A properly installed paver driveway on a correct base lasts 20 to 30 years in Dallas, and often longer. The pavers themselves rarely fail. The base and the joint sand do, which is why base prep and periodic sealing are what actually determine lifespan here. Call (844) 797-4808 for an honest assessment of what’s under yours.
Often yes, and we’ll tell you when. A localized area of popped pavers or a single rutted section can be lifted, re-based, and re-laid without touching the rest, and joint sand or sealing can reset a surface that’s still structurally sound. Whole-surface replacement only makes sense when the base has failed broadly or drainage is pushing water at your foundation. Call (844) 797-4808 and we’ll walk it with you.
Plan on three to seven days for a typical Dallas residential driveway, depending on square footage and whether removal and base repair are extensive. Concrete needs additional cure time before you drive on it, which we’ll schedule around your access. Get a written timeline in your free estimate – call (844) 797-4808.
We measure your existing pavers, identify the closest compatible profile and colorway from our material partners, and blend a sample on site before ordering. If an exact color match isn’t available, we’ll show you the closest option and where to place new pavers so it reads as intentional. We also work with KraftMaid, Cambria, and Silestone across other trades, and Belgard among our paver partners. Call (844) 797-4808 to schedule a free estimate.
If you’re ready for real answers on a driveway that’s failing, call Groundwork Construction Co. of Dallas at (844) 797-4808. We’ll schedule a free project estimate, give you an upfront line-item quote, and back the work with our 730-Day Done Right Promise. We pull the permits, pass the inspections, and answer the phone when you call.
Written by the team at Groundwork Construction Co. of Dallas, serving Dallas and nearby areas.