Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Master Halco Home Additions & ADU: The Dallas Owner’s Guide
We plan and build Master Halco-compatible home additions and ADUs in Dallas, with typical projects landing between $45,000 and $130,000 for an addition and $90,000 to $220,000 for a detached ADU, depending on size, foundation, and finishes. Every project starts with a free on-site estimate and a written, line-item scope, so you know the number before we break ground. If you’re already holding a plan or a set of panels and something’s gone wrong, we can pick it up from there.

Most Dallas owners don’t start with the word “Master Halco.” They start with a symptom: a sticking exterior door on the addition, a porch post that’s moving at the base, a panel that won’t line up, or a contractor who quoted a spec and delivered something else. Whether it’s finishes, framing, or a structural detail, our technicians have up to 12 years of experience diagnosing what’s actually wrong before anyone swings a hammer.
Which Master Halco Models This Applies To
Master Halco has historically been known for fencing, gates, and outdoor structures, so when it shows up in an addition or ADU project, it’s usually the exterior package: fencing, gate hardware, privacy screening, and outdoor structures that tie into the addition’s footprint. If your project references Master Halco material on the plans, the first job is confirming what spec was actually ordered, because the drawings and the delivered material don’t always match.
To identify what you’re working with, check three places: the panel or post for a stamped mark or part number, the original invoice or quote (the line item will name the series), and the plans themselves, which usually specify a series and gauge. A compatibility gotcha we see in Dallas: plans that call for a panel height and gauge that the original installer substituted, which changes post spacing and gate hardware sizing downstream. That’s why we measure before we order.
On the OEM-versus-aftermarket decision, the honest answer is that quality aftermarket hardware is often the right call for a repair, but structural panels and load-bearing posts should match the original spec where the plans call for it. Where an exact match isn’t available, we document the equivalent we’re using and why. We’re an independent service provider, not affiliated with Master Halco. For interior finishing of an addition or ADU, we also work with KraftMaid, Cambria, and Silestone.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Master Halco Home Additions & ADU Is Failing
These are the symptoms that bring Dallas owners to the phone, along with what’s usually underneath them:
- Posts or panels that move at the base. Dallas’s expansive clay soil swells and shrinks with the seasons, and shallow footings work loose. Movement at the base is a foundation and footing issue, not a cosmetic one.
- Rust at the welds and hardware. North Texas summer heat plus occasional hard rain cycles accelerate corrosion on lower-grade coatings. Rust blooming at connection points usually means the protective finish has failed, not just the paint.
- Gates that sag or drag. A gate that catches the ground is almost always hinge wear, post lean, or a hardware set sized for a lighter panel than was installed. It rarely fixes itself and it gets worse.
- Panels that won’t line up after a repair. This is the compatibility trap: replacement material in a different gauge or height than the existing run. The new piece fits the hole but not the structure.
- Water pooling at the addition’s exterior footprint. Grading that routes water toward the new slab or porch is common in older Dallas neighborhoods. It’s a project-level fix, and ignoring it shortens the life of everything around it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a Master Halco-related repair or exterior package within an addition, small repairs run a few hundred dollars up to around $3,000, while a full exterior re-wrap or structural correction inside a larger project can run $8,000 to $18,000. The full project ranges are the ones that matter here: home additions in Dallas run $45,000 to $130,000 and ADUs run $90,000 to $220,000, all installed.
| Scope | Installed Range |
|---|---|
| Home addition (full project) | $45,000 – $130,000 |
| ADU construction | $90,000 – $220,000 |
| Garage conversion | $30,000 – $80,000 |
| Exterior package repair / re-wrap | $8,000 – $18,000 |
What drives the range: square footage, slab versus pier foundation, whether permits and engineering are already pulled, and finish level. Our quotes are written line by line, parts and labor separated, so you see exactly what you’re paying for and what you’re not. The number you see is the number you pay. Every project carries our 730-Day Done Right Promise: if it’s not done right, we make it right.
DIY or Call Us?
What you can safely check yourself: the stamped part numbers on posts and panels, whether posts are plumb, whether water pools at the addition’s perimeter, and whether the gate hardware is the size the plans called for. Take photos and keep the original invoice handy – that’s all useful to us.
Where DIY goes wrong: resetting a post on swelling clay without addressing the footing, and replacing panels in the wrong gauge so the whole run misaligns. Those aren’t weekend fixes, and a failed repair on an addition means tearing out more than you started with. If your project involves structural, electrical, or plumbing changes inside the addition, that’s licensed work, and we’ll say so plainly.
Call (844) 797-4808 and a live person answers, 24/7, for a free estimate. We’ll tell you whether it’s a repair or a rebuild before you spend a dollar.
FAQs
A properly installed, quality-coated system typically gives you 15 to 20 years in North Texas, but Dallas heat and clay soil shorten that when footings are shallow or coatings are thin. Corrosion at the welds and movement at the base are the two things that cut lifespan fastest. Call (844) 797-4808 for a straight assessment of what you’ve got.
Often yes – if the posts are plumb and the corrosion is surface-level, a hardware and finish repair is the right call. If footings have moved or the material is structurally compromised, repair just delays the replacement. We’ll tell you which one you’re looking at, in writing. Call (844) 797-4808 for a free estimate.
A hardware or partial-panel repair is usually done in a single visit. A full exterior re-wrap on an addition takes two to four days depending on run length and whether footings need resetting. Full additions and ADUs run weeks to months, and we’ll give you the schedule with the quote. Call (844) 797-4808 to get yours.
We measure the existing spec first, then source the closest match from the brand partners we work with, documenting any equivalent we use. We don’t claim to stock parts or carry them on a truck, so lead time depends on the item. Call (844) 797-4808 and we’ll tell you what’s realistic for your job.
Ready to stop guessing? Call Groundwork Construction Co. of Dallas at (844) 797-4808 for your free estimate. Live person, 24/7. Upfront pricing, no surprises. From foundation to finish line, and built to last, backed in writing.
Written by the team at Groundwork Construction Co. of Dallas, serving Dallas and nearby areas.