Roofing
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Metal Roofing in University Park, TX: What It Costs and How Long It Takes
Metal roofing in University Park, TX runs $15,000 to $40,000 for a full install, and most homes here take six to ten working days once materials land on site. The number swings on roof square footage, panel type, and how much deck repair the tear-off exposes. Call (844) 797-4808 and we’ll walk your roofline, measure the actual squares, and put a written line-item quote in your hands before you commit to anything.
How a Metal Roof Goes On: Day by Day in University Park
Every roof we install follows the same sequence. The timeline shifts with square footage and weather, but the order doesn’t. Here’s what actually happens, and where you make decisions.
Stage 1: Tear-off and deck inspection (one to two days)
We strip the old shingles or tiles down to the deck, then walk every sheet of sheathing. On the 1920s to 1950s brick and frame homes that still anchor blocks off University Boulevard and around Caruth Park, that deck is often original 1×6 or thin plank that won’t hold a standing seam panel without overlayment. We photograph what we find and show you before adding anything to the ticket.
Stage 2: Deck repair and underlayment (one day)
Soft spots get cut out and replaced with new sheathing. Then the underlayment goes down – a high-temp synthetic rated for metal, not the standard felt a shingle crew uses. On homes near the mature live oaks that shade so much of University Park, we also check for limb strikes and organic debris that trap moisture against the deck.
Stage 3: Trim, flashing, and panel layout (one to two days)
This is where you decide panel color and profile – and where a metal roof is made or broken. Eaves, valleys, chimneys, and the penetrations from vents all get flashed correct before a single panel goes up. On tight 50- to 70-foot lots, delivery and staging get planned around alley access and side-yard clearances, so we schedule the material drop for the morning the crew is ready, not a day early.
Stage 4: Panel installation and fastening (two to four days)
Panels go on in courses, each fastened with the concealed clips or exposed screws your profile requires. Standing seam conceals the fasteners; exposed-screw panels don’t. We set the crew size to the square count so this stage doesn’t drag, because North Texas summer heat compresses the working window on a metal roof deck that can hit 150 degrees in direct sun.
Stage 5: Final inspection and cleanup (one day)
We walk the roof and the ground with you, run a magnet sweep for stray screws, and confirm the penetrations and ridge caps are sealed. Work on this roof is covered by our 730-Day Done Right Promise. If something isn’t right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Metal isn’t one product. The profile and panel you pick drives both the price and how the roof looks from the street, which matters on a Park Cities block where neighbors notice.
- Standing seam panels: Concealed fasteners, clean vertical lines, the premium look. Expect the top of our price range. Best for homeowners who want the roof to look intentional for the next 40 years.
- Exposed-screw panels (through-fastened): Lower cost, faster install, and honest about what it is. The trade-off is visible washers that need checking every few years as the rubber ages in the heat.
- Stone-coated steel: Made to mimic tile or shake while shedding far less weight. A common pick on University Park rebuilds where the design calls for a traditional look but the structure can’t carry the load of real tile.
- 24-gauge vs 26-gauge steel: The heavier gauge resists hail dents and oil-canning – that wavy reflection you see on cheap panels in bright sun. On a North Texas roof that takes periodic hail, 24-gauge is usually the right call.
- Paint finish and warranty tier: A 40-year finish system costs more than a 20-year one and holds color better under UV. We use finishes we can stand behind in writing.
If windows factor into the same remodel, homeowners often pair this with Window Replacement in University Park so the envelope work happens in one coordinated push.
What Metal Roofing Costs in University Park, TX
Most metal roof installs here land between $15,000 and $40,000. That range covers tear-off, deck repair, underlayment, panels, and flashing. Five things push a job toward the low or high end:
- Roof size and complexity: A simple gable at 22 squares prices very differently than a hip roof with multiple valleys and dormers.
- Panel type and gauge: Standing seam 24-gauge sits at the top; exposed-screw 26-gauge sits at the bottom.
- Deck condition: Original plank sheathing on an older cottage may need full redecking. That’s a real line item, not a surprise we spring mid-job.
- Penetrations and flashing: Chimneys, skylights, and multiple roof planes add labor.
- Permit and inspection scope: University Park runs its own review, and two-story rebuilds often mean additional structural coordination.
Your written estimate breaks each of those out. The number you see is the number you pay. No change orders unless you approve a change in scope, and we finance at 0% for 18 months if spreading the cost helps. $1,000 off applies on projects over $10,000.
See the difference
Before
After
Before
After
Before
AfterWhat University Park Homes Specifically Do to This Job
University Park is built out. There’s essentially no vacant land left in this landlocked Park Cities enclave, so nearly every metal roof we install lands on a lot that already has a house on it – either an original 1920s-1950s brick and frame cottage or a newer custom build on a 50- to 70-foot lot. That changes the work. On the older homes, tear-off regularly exposes pier-and-beam framing and decades of patchwork, and we plan for redecking the day we open it up. On newer builds, the metal roof is usually part of a pop-and-add or a full rebuild where the design already calls for it.
Alleys back many blocks, and mature live oaks canopy the side yards, so staging, material delivery, and protecting existing trees become as decisive as the install itself. University Park runs its own permitting and inspection process, and roof work here is a routine review rather than an exception – which means we pull the permit and pass the inspection as part of the job, not as a separate headache you chase. Hail-rated roofing isn’t optional in North Texas; it’s the line item that keeps the next storm from becoming a claim.
When a metal roof is part of a larger scope, it’s usually part of a full Roofing in University Park plan, and we’re glad to coordinate it. We also handle impact-rated glazing, and homeowners often pair this with Impact Windows & Doors in University Park so the whole envelope is storm-ready.
Serving University Park, TX – Our Local Coverage Area
We serve University Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Metal Roofing in University Park
Most jobs take six to ten working days, from tear-off to final walkthrough. Larger roofs, complex rooflines, or heavy deck repair push toward the high end. Call (844) 797-4808 for a timeline specific to your roof.
Yes. University Park requires a permit for roof replacement, and we pull it as part of the job. The city runs its own review, so we handle the paperwork and the inspection. Call (844) 797-4808 and we’ll walk you through what the permit covers.
Usually, yes. Metal is lighter than tile and often lighter than the shingles coming off, so most homes don’t need structural reinforcement. Stone-coated steel and standing seam both install over the existing deck once it’s sound. We confirm it during the deck inspection.
Expect $15,000 to $40,000 depending on square footage, panel type, gauge, and deck condition. Call (844) 797-4808 for an exact written quote – estimates are free.
Our workmanship is covered by the 730-Day Done Right Promise, and the panel manufacturer’s finish warranty runs alongside it (typically 20 to 40 years depending on the tier you choose). If it’s not done right, we make it right. Call (844) 797-4808 to review the coverage for the panel you pick.
Get a Free Metal Roofing Estimate in University Park
We’ll walk your roofline, measure the actual squares, and hand you a written, line-item estimate for metal roofing in University Park – no pressure, no vague bid. Our technicians have up to 12 years of experience, arrive background-checked and in uniform, and every job is backed by the 730-Day Done Right Promise. Calls are answered by a live person 24/7. Visit our Roofing service or the University Park area page, or call (844) 797-4808 today.
Written by the team at Groundwork Construction Co.