Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Farmers Branch, TX: What the Job Actually Involves
A paver driveway in Farmers Branch usually runs $7,000 to $18,000, takes three to five working days on site, and starts with a base that’s dug deeper than most homeowners expect. We tear out the old slab or gravel, excavate 8 to 12 inches, compact the subgrade, and lay a geotextile separation layer before a single paver shows up. Call (844) 797-4808 for a free on-site estimate with a written line-item quote.
When you’re pricing Paver Driveways in Farmers Branch, you’re really pricing the base, the edge restraint, and the pavers, in that order of importance. Anyone who quotes you on pavers alone is selling you a future repair.
Key takeaways
- Paver driveways in Farmers Branch run $7,000 to $18,000 depending on square footage, base depth, and paver grade.
- Expect three to five working days on site, with a permit review that can add one to three weeks before that.
- The base matters more than the paver. Clay soil here demands it.
- Written line-item estimates, permits pulled, and a 730-Day Done Right Promise on the workmanship.
How We Build Paver Driveways in Farmers Branch, Stage by Stage
We run this job in five stages, and we tell you upfront which day each happens so you’re not guessing about when the driveway is usable again.
Stage 1: Site walk and layout (day 1, half a day)
We mark the driveway edges with string and stakes, check the slope away from the garage door, and confirm where the expansion joint meets the existing slab. You decide the paver pattern, color blend, and border band at this stage. Changes after this point cost money, so it’s worth taking an extra day to think it through if you’re unsure.
Stage 2: Demo and excavation (day 1 into day 2)
Old concrete, asphalt, or gravel comes out first and gets hauled away. Then we excavate to the depth your base needs, typically 8 to 12 inches depending on your soil and load. In Farmers Branch that depth usually runs on the high end because of the clay.
Stage 3: Base, compaction, and edge restraint (day 2 into day 3)
We lay a geotextile fabric, then bring in crushed stone base in 3-inch lifts and compact each lift with a plate compactor. This is the single most important stage and the one we refuse to rush. The edge restraint goes in before the sand bedding so the driveway doesn’t spread under load over the years.
Stage 4: Paver laying and cutting (day 3 into day 4)
Pavers go down in your chosen pattern, and every cut at the garage apron, walkway tie-in, and street edge gets made with a wet saw, not a hammer and chisel. You’ll walk out and see the driveway taking shape. It’s worth a look so any pattern question gets settled before the sand goes in.
Stage 5: Polymeric sand, cleanup, and final walkthrough (day 4 into day 5)
We sweep polymeric sand into the joints, mist it to activate, and let it cure. Then we walk the finished driveway with you, show you the drainage, and hand over the written workmanship documentation. You can drive on it usually within 24 to 48 hours after the sand cures, and we tell you the exact date before we leave.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Paver Options You’ll Choose Between
Most of the decisions on a paver driveway are made in one conversation. Here’s what actually changes the look, the cost, and the lifespan.
- Concrete pavers (the default): Dense, uniform, and the most forgiving in North Texas heat. Hit the $7,000 to $12,000 end of the range on standard rectangular formats. Colors and textures range from single-tone gray to multi-color blends that mimic old brick.
- Clay brick pavers: Warmer look, classic on older ranch homes, and they hold color longer than concrete. Costly, typically $11,000 to $18,000 depending on size and pattern, and they take slightly more care against freeze-thaw in a bad winter.
- Permeable pavers: Open joints or larger gaps that let water drain through. Worth considering if your lot drains toward the garage or the street, which is common on the older, flatter lots near the Dallas line. Costs about 10 to 15 percent more than solid pavers.
- Paver grade and thickness: Standard 2-3/8 inch pavers are fine for residential driveways. If you have heavy vehicles or a long run, a thicker paver and deeper base pays for itself.
- Pattern and border: Herringbone, running bond, and basketweave are the standards. A contrasting border band adds $500 to $1,200 but sharpens the edges and helps at the driveway apron where cars pull in at an angle.
- Color band selection: Worth picking from a real sample, not a photo. Sun exposure changes how these read in person.
Our driveway & pavers service uses a curated material set, and brand partners in this category include Belgard, so you’re choosing from products we’ve actually installed, not just what a supplier happened to have in stock.
What Paver Driveways Cost in Farmers Branch, TX
Paver driveways in Farmers Branch run $7,000 to $18,000 for a typical residential driveway. That range covers demo, excavation, base, compaction, pavers, polymeric sand, and haul-away. What pushes a job to the high end comes down to a handful of variables.
- Square footage: A standard two-car driveway runs 400 to 500 square feet. Every extra 100 square feet adds roughly $1,500 to $2,500.
- Base depth and soil condition: If the clay is stubborn and wet from a spring storm, we may need to over-excavate and bring in more stone, adding $800 to $2,000.
- Paver grade and material: Concrete pavers sit at the low end. Clay brick pushes toward the high end.
- Existing driveway removal: Thick concrete with rebar is slower and more expensive to break out than thin asphalt or gravel.
- Permit scope and inspection: Sometimes the driveway change requires a permit and sometimes it doesn’t, but if your project touches the right-of-way or an adjacent structure, the review adds time and cost.
Your written estimate breaks out each line: demo, base material, pavers, border, and labor. If the number on the page is the number you pay, we put it in writing before we start. No dollar figure moves after the work starts unless you approve a change.
See the difference
Before
After
Before
After
Before
AfterWhat Farmers Branch Homes Specifically Do to This Job
Farmers Branch is a fully built-out inner-ring suburb, and there’s almost no new residential land inside ZIP 75234. Nearly every paver driveway job we run here is a replacement or an upgrade on an existing property, not a driveway for new construction. That means the driveway has to fit between a 1950s to 1970s ranch house, a garage apron that was probably poured when the home was built, and a lot line that hasn’t moved in sixty years.
The housing stock matters. Mid-century ranches near the Dallas line, small post-war cottages, and the redeveloped lots along I-35E and Valley View all present different driveway problems. On the older homes, we regularly see original concrete slabs that have heaved and cracked from the Blackland Prairie clay underneath. That clay swells hard in wet springs and shrinks in drought, and it does the same thing to a paver driveway base if it isn’t excavated and compacted correctly. The pavers themselves are the easy part. The base is where Farmers Branch drives fail.
Permitting is another real factor. The city enforces codes and permits on older properties, and the driveway often sits in the middle of a larger remodel or a whole-home rebuild. If your paver driveway is part of a full Driveway & Pavers in Farmers Branch project, we sequence the driveway after any foundation or utility work is finished so you’re not redoing the base a year later. If you’re building a separate structure or converting existing space, homeowners often pair this with ADU Design & Permitting in Farmers Branch or a Garage Conversion ADU in Farmers Branch, and the driveway plan has to account for both.
We serve all of ZIP 75234 and surrounding areas. If you’re in Farmers Branch and want to talk specifics, our Farmers Branch service page lists what we cover.
Serving Farmers Branch, TX – Our Local Coverage Area
We serve Farmers Branch and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Paver Driveways in Farmers Branch
A typical paver driveway takes three to five working days on site. Permit review, if required, can add one to three weeks before that. Weather matters: heavy spring rain in North Texas will push excavation back, so we build a weather buffer into the schedule. Call (844) 797-4808 for a schedule estimate on your specific driveway.
Often no, but it depends on whether the work touches the right-of-way or ties into an existing structure. When a permit is required, we pull it and handle the inspection. We check the requirement at the estimate stage, not after the work is half-done. Call us to confirm for your address.
We don’t recommend it, and we won’t quote it as an equal option. A paver driveway needs a compacted base and a proper edge, and covering old, cracked concrete just carries the damage up through the new surface. The honest answer is that demo and rebuild is the right move in Farmers Branch’s clay soil.
Yes, if it’s built correctly. Concrete pavers take the heat better than asphalt, and the polymeric sand joints flex with the seasonal soil movement instead of cracking. The base depth and compaction are what determine how long it lasts. Done right, it’s a driveway we expect to hold for decades.
Every paver driveway we install is covered by our 730-Day Done Right Promise: if the workmanship fails, we make it right. That covers install issues like settling, joint failure, and edge spread. Material warranties on the pavers themselves come from the manufacturer and we hand those over at the final walkthrough.
Get a Free Paver Driveway Estimate in Farmers Branch
We’ll come out to your Farmers Branch property, measure the driveway, check the base, and give you a written line-item estimate with the exact number you’ll pay. No pressure, no guessing, and a live person answers the phone any time you call. The estimate is free, the pricing is upfront, and every paver driveway we install is backed by the 730-Day Done Right Promise. Call (844) 797-4808 to schedule yours.
Written by the team at Groundwork Construction Co.