Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Driveway Repair & Replacement in Farmers Branch, TX: What It Takes
Driveway repair in Farmers Branch usually runs $400 to $1,800 for cracks, settling and surface damage, while a full replacement runs $5,000 to $14,000 and takes two to four days from tear-out to cure. Most of the driveways we see here are original slabs poured alongside 1950s to 1970s ranch homes, and the Blackland Prairie clay underneath has had fifty years to push, drop and crack them. Call (844) 797-4808 and we’ll send someone out for a free on-site estimate before you commit to repairing anything.
How We Hand a Farmers Branch Driveway From Tear-Out to Cure
Every replacement follows the same sequence. The details change from job to job, but the order doesn’t, and knowing it means you’ll know what to expect on each day.
- Stage 1 – Site visit and layout (day 1, 45 to 90 minutes). We walk the drive, check slope toward the street and garage, and probe the base under any sunken sections. You decide the width, the finish and whether you’re matching the existing apron or replacing it. This is also when we confirm whether the job is a repair or a replacement. Some slabs are worth saving. Many in Farmers Branch aren’t, and we’ll tell you which one you have.
- Stage 2 – Utility locate and permits (2 to 5 business days). We call in the locate before any digging, and the City of Farmers Branch requires a right-of-way permit when the work touches the approach apron between your property line and the street. We pull that and schedule the inspection. You don’t have to chase paperwork.
- Stage 3 – Demo and haul-off (day 1 of construction, 4 to 6 hours). Concrete comes out with a skid-steer and breaker, loaded into dumpsters and hauled away. Paver or asphalt driveways come up faster. By evening you’ll see bare subgrade and know exactly how much base was failing.
- Stage 4 – Grading and base (day 2, 5 to 7 hours). We re-grade the subgrade to drain away from the garage and house, then compact 4 to 6 inches of crushed limestone base in lifts. On the heavy clay here, base prep is where a driveway is won or lost. A slab poured over bad base fails in three winters.
- Stage 5 – Pour, finish and cure (day 3, 4 to 6 hours, then 7 days of curing). Concrete goes in, gets floated and finished, and gets saw-cut control joints within 24 hours. You’ll stay off it for a week. Pavers go down in a day with a compacted sand setting bed.
On a repair rather than a replacement, stages 1, 2 and 5 apply, and the middle collapses into a single day: route and clean the cracks, fill with a flexible sealant or epoxy, and address any settled panels with mudjacking or polyurethane foam lifting. Most repairs are a one-day visit, and you’re driving on the surface within hours of the crew pulling out.
If the drive ties into a wider project – a new patio, a walkway to a front door, or landscaping around the garage – this work is typically part of a full Driveway & Pavers in Farmers Branch project, and we’ll scope it that way from the first estimate.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Four decisions drive most of the cost and all of the longevity. Come into the estimate knowing what each one buys you.
- Concrete (broom-finished). The default in Farmers Branch, and for good reason. It runs $4,500 to $12,000 for a full replacement, holds up 25 to 30 years in this climate, and needs almost nothing from you except sealing every few years. The trade-off is that it cracks. Saw-cut control joints manage it; they don’t eliminate it.
- Concrete with a decorative finish. Stamped or exposed-aggregate concrete costs 20 to 40 percent more than broom-finished and gives you the look of stone or pavers without the maintenance. It suits homeowners who want a driveway that reads as part of the landscaping rather than an afterthought. Stamped surfaces do need re-sealing every two to three years to keep the color and repel stains.
- Pavers. Clay or concrete pavers sit at the top of the range and are the most repair-friendly option because a single damaged unit comes up and goes back without touching its neighbors. They also flex with the clay instead of fighting it. You’ll pay more up front and you’ll need to top off the joint sand periodically. For a driveway taking heavy truck traffic or a long pull to a detached shop, pavers are worth the conversation.
- Asphalt. The lowest up-front cost, $3,500 to $9,000, and the fastest install. In North Texas heat, asphalt softens in July and August and needs a seal coat every two to three years to hold up. It’s a reasonable choice if you’re planning to sell within a decade or the driveway is a secondary one.
Whichever finish you pick, the subgrade and base underneath are non-negotiable. Ask any contractor what base thickness they’re putting in. If the answer is vague, that’s your answer.
What Driveway Repair & Replacement Costs in Farmers Branch, TX
A driveway replacement in Farmers Branch runs $5,000 to $14,000, and a repair runs $400 to $1,800. Those are real numbers for real driveways here, not a national average. Where you land depends on five things:
- Square footage. A typical two-car drive in this city is 400 to 600 square feet. A long pull to a detached workshop or a widened turnaround adds hundreds of square feet and thousands of dollars.
- Existing condition. Cosmetic cracks are a repair. Widespread alligator cracking, settled panels or failed base under half the drive means full replacement, even if you hoped otherwise.
- Base and subgrade work. If the clay has pushed the slab up or dropped it, we’re re-grading and re-compacting, and that’s a real line item. Expect $1,500 to $4,000 when the base has to be rebuilt.
- Drainage and utility conflicts. Relocating a gas line, water meter or downspout, or adding a channel drain to move water away from a low garage, adds cost. Permit fees for the right-of-way apron run a few hundred dollars.
- Material and finish. Broom-finished concrete is the floor. Pavers, stamped concrete and exposed aggregate push the number up.
Every written estimate we hand you is line-itemed: square footage, base depth, material, permits, haul-off, and finish. No change orders mid-job for things that were visible on day one. If a repair is the smarter call, we’ll say so, even though a replacement is the bigger ticket. We back the workmanship on either under the 730-Day Done Right Promise, and our technicians bring up to 12 years of experience to the finish work that shows.
See the difference
Before
After
Before
After
Before
AfterWhat Farmers Branch Homes Specifically Do to This Job
Farmers Branch is a small, nearly built-out inner-ring suburb. Almost no new residential land exists here, so the driveways we work on are the original slabs poured alongside mid-century ranch homes, many from the 1950s through the 1970s, plus a fair share of rebuilds and additions now pushing south toward the Dallas line around Brook Hollow and Marsh Lane. That matters because fifty-year-old concrete is at the end of its life, not the middle of it, and the Blackland Prairie clay underneath has been working on it the whole time. You’ll see the pattern in driveways off Valley View and along the older streets feeding into it: a slab that cracked in one drought, heaved in the next wet spring, and never quite settled back.
The city enforces codes and permits on older properties, and the right-of-way apron in front of your garage is city property. We pull that permit and get the inspection passed rather than hoping nobody looks. HOA rules on driveway finishes also apply in several Farmers Branch subdivisions, so we check what’s approved before you fall in love with a stamped pattern. Spring hail and straight-line wind don’t hurt driveways directly, but they’re a reminder that anything outside the house takes a beating here, and a well-built slab with proper joints and drainage handles it.
We cover the whole city and the surrounding stretch – Farmers Branch and its neighbors Addison, Carrollton, Irving and Coppell are all within reach. If your project grows into an outbuilding or a converted space, homeowners often pair this with ADU Site Prep & Utilities in Farmers Branch or a Junior ADU & Interior Conversion in Farmers Branch, and we can scope both at once. For the broader picture of everything we do on driveways, patios and walkways, see our Driveway & Pavers service.
Serving Farmers Branch, TX – Our Local Coverage Area
We serve Farmers Branch and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Driveway Repair & Replacement in Farmers Branch
A full replacement takes two to four days of active work, plus a seven-day cure before you park on concrete. Add two to five business days at the front for the right-of-way permit if the apron is being replaced. Call (844) 797-4808 for a date and schedule.
Yes, if the work touches the apron between your property line and the street. Repairs that stay inside your property line usually don’t require one. We pull the permit and schedule the inspection, and we’ll tell you on the estimate whether your job needs one.
Often, yes. Cracks, settled panels and surface damage are repairable for $400 to $1,800 when the foundation base is still sound. If more than a third of the slab has failed or the base has shifted, a replacement is the honest answer, and we’ll show you the reason on-site rather than just quoting the bigger number.
Repairs run $400 to $1,800, and replacements run $5,000 to $14,000 for a typical two-car drive. A long drive to a detached shop, a rebuilt base or a paver finish pushes you toward the top of that range. Call (844) 797-4808 for a written line-item estimate – it’s free.
Workmanship is covered by our 730-Day Done Right Promise on repairs and replacements alike – if it’s not done right, we make it right. Material warranties come from the manufacturer and we’ll spell those out in writing on your estimate. Call (844) 797-4808 to schedule a free estimate.
Get a Free Driveway Estimate in Farmers Branch
If your driveway is cracked, sunken or past saving, get a real number before you decide anything. Call (844) 797-4808 for a free on-site estimate in Farmers Branch. A live person answers around the clock, and we’ll walk the driveway with you, tell you repair or replacement, and hand you a written line-item price with no surprises. Projects over $10,000 get $1,000 off, and 0% financing for 18 months is available.
Written by the team at Groundwork Construction Co.