Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Irving, TX: What to Expect
Concrete driveways and concrete work in Irving, TX run $4,500 – $12,000 for a new driveway, with most South Irving and Las Colinas installs landing between $7,000 and $9,500. A standard pour takes two to three working days to place and about seven days before you park on it. Call (844) 797-4808 for a free on-site estimate with a written, line-item price.
How a concrete driveway goes from demolition to cured slab
Concrete is a scheduling job more than a building job. The pour is fast. Everything that makes that pour last is what happens before the truck shows up. Here’s the actual sequence we run on an Irving concrete project.
Stage 1: Site walk and layout (day 1, about an hour)
We measure the existing approach, check where the city sidewalk and driveway apron meet the street, and confirm the finished slab height against your garage door threshold. This is where you decide width (a single 12-foot lane or a double 20-foot pad), whether you want an apron flare, and whether the new drive ties into an existing walkway. Getting the door clearance wrong is the number one cause of callbacks, so we settle it with a tape measure before anything gets torn out.
Stage 2: Demolition and haul-off (day 1 – 2)
Old concrete, root-damaged sections, and failed patches come out with a skid-steer and pneumatic breakers. On South Irving lots the existing slab is often a 4-inch non-reinforced pour from decades ago, which breaks up quickly. Haul-off runs about $500 – $1,200 depending on cubic yards. You don’t have to decide anything here, but you do want to see the base before we cover it back up.
Stage 3: Grading, base, and reinforcement (day 2 – 3)
This is the stage North Texas clay makes non-negotiable. We cut to subgrade, proof-roll the clay, and haul in 4 to 6 inches of select fill or crushed limestone base. Then it gets compacted in lifts, because a single thick layer won’t hold. Rebar or welded wire mesh goes in next, typically #3 rebar on 18-inch centers for a driveway that will see trucks and trailers. You decide here whether to add a thickened edge where the slab meets grass or a retaining wall.
Stage 4: The pour (day 3, early morning)
Irving summer heat pushes every concrete crew to a 5 or 6 a.m. start. Concrete that sets too fast in an 98-degree afternoon finishing window cracks before it cures. We place, screed, float, and broom-finish the surface, then cut control joints within the first 12 hours. Joint spacing matters more than people realize: a slab that skips joints will crack wherever the clay decides to move. Your decision at the pour is finish texture (broom, exposed aggregate, or a salt finish) and edge style.
Stage 5: Curing and inspection (days 4 – 10)
We keep the slab damp for the first few days and tell you to stay off it for at least 48 hours and off vehicles for a week. Framework is typically complete in three days. Full cure is weeks, but the drive is usable in about seven. If the job needs a city right-of-way permit for the approach apron, the inspection happens after the pour and can add a few business days to closeout.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The concrete options you’ll actually be choosing between
- Standard broom-finish concrete (5 – 6 inch slab): The default and best value. Readable texture, good traction in rain, $4,500 – $9,000 for a typical Irving drive. It suits most homes and won’t date the property.
- Reinforced vs. unreinforced: On black-clay soil, reinforcement is worth the extra $400 – $900. Unreinforced slabs are the ones that crack in a straight line across a swale.
- Exposed aggregate or salt finish: Adds $600 – $1,500 for the decorative texture. Nicer curb appeal, harder to repair cleanly, and if you like a clean uniform surface, this isn’t it.
- Concrete steps, stoops, and approach pads: Often added on the same pour and priced per square foot. Bundling them saves a return trip.
- Subbase upgrades: On problem lots with active drainage, a deeper base or drainage trench adds $800 – $2,000 and can be the difference between a drive that survives ten wet-dry cycles and one that doesn’t.
We only quote materials we’re confident will hold up on North Texas clay. If you’re also planning the wider front-of-house project, our Driveway & Pavers service covers the full-scope side of that work.
What concrete driveways and concrete work cost in Irving, TX
Expect $4,500 – $12,000 for a new concrete driveway in Irving, based on typical local square footages and current material pricing. Here’s a line-item look at where that range splits.
| Item | Typical Irving range |
|---|---|
| Concrete driveway installation (new pour, broom finish) | $4,500 – $12,000 |
| Driveway replacement (demo included) | $5,000 – $14,000 |
| Concrete approach apron / sidewalk replacement | $900 – $2,400 |
| Concrete steps and stoop | $700 – $2,000 |
| Exposed aggregate or decorative finish add-on | $600 – $1,500 |
Four variables move that number. First, size: a single-car drive is roughly half the slab of a two-car pad. Second, demolition and haul-off: breaking out old concrete and hauling it away runs $500 – $1,200 by itself. Third, subgrade condition: if the clay is active or drainage is poor, base and grading work adds to the base price. Fourth, finish and reinforcement: decorative finishes and rebar both add. A written estimate from us lists the demolition, base, reinforcement, and finish separately so you can see exactly what’s driving your number.
See the difference
Before
After
Before
After
Before
AfterWhat Irving homes specifically do to this job
Irving is two construction markets stitched together along the SH-114 corridor, and it changes what we pour. On the 1950s-to-1970s brick-veneer ranches around the old downtown, Hospital District, and South Irving, the original driveways were often 4-inch pours on shallow footings, and they’ve been cycling through black-clay swelling for six decades. We see the classic straight-line crack through the middle of the slab and the lifted edge where the clay pushed up against the garage. When a homeowner is scraping and rebuilding or adding a room, we often pour the new drive wider than the original lot supported, which means a fresh grading and subbase plan. In the Las Colinas, Valley Ranch, and 75038/75039 edge, the drives are younger, but HOA rules on color and finish are stricter and we confirm those before pouring.
Permits follow the same split. Right-of-way approach work through the city runs on its own timeline, and demolition-rebuild jobs in 75062 go through plan review that can add days to closeout. That’s a scheduling reality we plan around, not something we discover on the pour date. If you’re also looking at converting a garage into livable space, homeowners often pair that with a new driveway pour, and we handle Garage Conversion ADU in Irving and New Detached ADU in Irving as part of the same scoped project. We work across all four Irving ZIPs (75037, 75038, 75039, 75062) and nearby Irving neighborhoods.
Serving Irving, TX – Our Local Coverage Area
We serve Irving and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked questions about concrete driveways and concrete work in Irving
Most Irving concrete driveways are constructed in two to three working days, with vehicle traffic allowed after about seven days of curing. Framing and demolition of the old slab can add a day on older South Irving lots where the base needs full replacement. Call (844) 797-4808 for a project-specific timeline.
Permits are typically required when the work touches the city right-of-way, the approach apron, or sidewalk, and not for a private driveway fully behind the property line. Plan review on the approach side can add a few business days. We confirm what your specific job needs during the free estimate.
No. Our written estimate is the number you pay on a standard concrete job, and we don’t add change orders unless you approve a scope addition. The main thing that can legitimately move a price is discovering unmarked utilities or a failed base zone after demolition, and we show you that finding before we proceed.
Yes, reinforcement is strongly recommended on Irving’s black-clay soil because the wet-dry cycle swells and shrinks the subgrade and pulls unreinforced slabs apart. We typically use #3 rebar on 18-inch centers or welded wire mesh, and the decision between the two is a cost and loading question we walk you through.
Every concrete project we complete is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s backed by a written workmanship warranty and a crew that arrives background-checked and in uniform. Ask for the warranty terms in writing at estimate.
Get a free, written concrete estimate in Irving
A free on-site estimate means we measure the drive, check the base and drainage, and hand you a line-item price before any work is scheduled. You’ll know the slab size, reinforcement, finish, and permit status up front. Call (844) 797-4808 to schedule yours, and a live person answers any time so you’re not waiting until Monday.
Written by the team at Groundwork Construction Co.