Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Highland Park, TX: What You’re Actually Getting
A chain link fence in Highland Park, TX runs $3,500 to $9,000 installed, and most residential lots are wrapped in two to four days once the crew mobilizes. The number that matters more here is wind: this is a fence that has to hold up to North Texas spring straight-line gusts and hail-driven debris, on tight lots under a mature tree canopy. Call (844) 797-4808 and we’ll walk your lot before anyone quotes it.
How a Chain Link Fence Goes In, Stage by Stage
We don’t treat this as a drop-off-and-leave job. Here’s the actual sequence, so you know what’s happening on your property and when to make decisions.
Day 1: Line layout and utility locate
Before a single post goes in, we call for the utility locate and walk the fence line with you. On a Highland Park lot this is where the mature canopy matters: we confirm the exact path around root zones and settle on corner post positions, because corners set the whole geometry. You’ll decide gate placement at this stage, and it’s the one decision you can’t easily undo later. Allow a few hours.
Day 1 – 2: Removal of what’s there
If an old fence stands, we pull posts, panels, and concrete footings. A short residential run takes a few hours; a full perimeter with set-in-concrete posts can eat most of a day. We haul it out, so you’re not left with a pile on the alley.
Day 2: Post setting
Line posts, corner posts, end posts, and gate posts get set in concrete to depth and left to cure. Terminal posts (corners and gates) take the tension load, so they’re set deeper and anchored heavier than line posts. This is the part homeowners never see and the part that determines whether the fence stays plumb after a storm. Typically cures overnight, longer in cool weather.
Day 3: Rails, mesh, tension, and gates
Top rail goes up, the chain link mesh gets stretched and tied off, tension bars lock it to the terminal posts, and gates hang and get adjusted for swing. This is the day it starts looking like a fence. You’ll walk it with us before we leave and flag anything that needs attention.
Day 3 – 4: Final walkthrough
We check plumb, tension, gate operation, and any concrete work tied in, like a mow strip or a gate anchor block. You get a written record of what was installed. If anything’s off, the 730-Day Done Right Promise covers it: if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Actually Change the Job
Chain link isn’t one product. Here’s what you’ll be deciding between, and the honest trade-off on each.
- Galvanized steel vs. vinyl-coated. Standard galvanized is the value pick and holds up fine in North Texas heat. Vinyl-coated (in black or green) costs more but looks less industrial and blends into landscaping. On a historic Highland Park property where curb appearance matters, the coated option is often the better call.
- Mesh gauge and height. Residential mesh is typically 11 or 9 gauge; heavier gauge resists hail and impact better and lasts longer under wind load. Height runs 4, 5, or 6 feet. A 5-foot run with heavier gauge is the sweet spot for most homes here.
- Post and rail weight. Terminal posts and top rails come in different wall thicknesses. The cheap spec flexes; the heavier spec holds. This is the single biggest driver of whether a fence survives a spring windstorm.
- Gate hardware and configuration. Walk gates, drive gates, double swings. A drive gate on a Highland Park lot with a narrow side yard needs a proper drop rod and heavier hinges, not the flimsy setup that sags within a year.
- Finishing touches. Privacy slats, tension wire at the bottom to close the gap, top rail caps, and a concrete mow strip. Each is priced separately, and each is worth asking about up front.
What Chain Link Fence Costs in Highland Park, TX
Plan on $3,500 to $9,000 for a residential chain link fence in Highland Park, installed. That’s the working range; here’s what pushes a job to the low or high end.
| Factor | Effect on price |
|---|---|
| Linear footage and lot size | Small perimeter near the low end; large or irregular lot pushes high |
| Existing fence removal | Adds cost if posts are set in concrete and need pulling |
| Mesh gauge and coating | Vinyl-coated and heavier gauge run more than standard galvanized |
| Gates | Each walk or drive gate is priced separately; drive gates cost more |
| Site access and tree cover | Tight side yards and root zones under the canopy slow the work |
A written estimate covers the linear footage, post spacing, gauge and coating spec, gate count and hardware, concrete for footings, removal and haul-off, and cleanup. It won’t cover what nobody scoped: unexpected root obstruction, a hidden utility conflict, or a gate added after the fact. Those get priced as a line item before we touch anything. Terms are upfront pricing, no surprises: the number you see is the number you pay. Financing at 0% for 18 months is available, and projects over $10,000 take $1,000 off.
See the difference
Before
After
Before
After
Before
AfterWhat Highland Park Homes Specifically Do to a Chain Link Job
Highland Park is a nearly fully built-out enclave of century-old homes where construction almost always means renovation, addition, or teardown-rebuild, and fencing follows the same pattern. You’re rarely starting on open ground. You’re working around 1910s to 1930s Tudor, Colonial, and Mediterranean houses on small lots, many expanded lot-line to lot-line over the decades. That means property-line fences often sit right up against a neighbor’s mature pecan or live oak, and the tree-protection reality shapes where posts can go. Mature canopy over the narrow streets is a real constraint on deliveries and equipment, and we plan around it rather than discovering it on day one. The Town of Highland Park runs its own permitting and design review rather than Dallas codes, and its lot-coverage rules apply to fence height and setbacks. North Texas hail and spring windstorms are the recurring failure mode: we see downed panels, bent top rails, and posts leaning after a heavy blow, especially where an old fence was set shallow. Highland Park properties in the 75205 ZIP are worth checking against the town’s requirements before anyone digs. If the driveway or walkway is getting torn up in the same project, homeowners often pair this with Concrete Driveways & Concrete Work in Highland Park or Asphalt Driveways & Resurfacing in Highland Park while the equipment’s already on site. This is part of a full Fence Installation in Highland Park scope, and if you’re weighing the wider project, our Fence Installation service covers the full range. We work across Highland Park and the surrounding area, and our technicians have up to 12 years of experience.
Serving Highland Park, TX – Our Local Coverage Area
We serve Highland Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Highland Park
Most residential chain link fences in Highland Park are finished in two to four working days, weather permitting. Removal of an old fence and concrete-cured post setting add a day; a simple perimeter on an open lot can wrap faster. Call (844) 797-4808 and we’ll give you a realistic schedule for your lot, not a generic one.
Highland Park runs its own permitting and design review rather than Dallas codes, and fence height and placement are subject to the town’s lot-coverage rules. The safe move is to confirm requirements before digging, and we handle that step as part of the job. Call (844) 797-4808 and we’ll walk you through what applies to your property.
Yes, in most cases, though a mature pecan or live oak near the property line changes where posts can safely go. We layout the line around root zones and confirm gate and corner positions before setting anything. Call (844) 797-4808 for a free on-site estimate, and we’ll flag any access limits up front.
Expect $3,500 to $9,000 for a residential chain link fence in Highland Park, depending on footage, gauge and coating, gate count, removal of the old fence, and site access. You get a written line-item quote before work starts. Call (844) 797-4808 for your free estimate.
Every chain link fence we install is covered by the 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it’s in writing. Call (844) 797-4808 to get your project started.
Get a Free Chain Link Fence Estimate in Highland Park
Call (844) 797-4808 to schedule a free on-site estimate for your chain link fence in Highland Park. We’ll walk the line with you, check for tree and utility conflicts, confirm gate placement, and hand you a written, upfront price with no surprises. A live person answers the phone around the clock. Most estimates take one visit.
Written by the team at Groundwork Construction Co.