Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in University Park, TX: What the Job Actually Involves
A chain link fence in University Park, TX usually runs $3,500 to $9,000 installed, with most residential jobs landing in the $4,500 to $7,000 range for 100 to 180 linear feet on a standard 50- to 70-foot lot. A straightforward run takes one to three days on site. Call (844) 797-4808 for a free on-site estimate and a written line-item price before any work starts.
How We Build a Chain Link Fence in University Park, Stage by Stage
Chain link looks simple from the street. The part that decides whether it’s still straight after five North Texas summers is the layout and the concrete. Here’s the real sequence we run.
Day 1, morning: walk the line and call 811. Before anything gets dug, we mark the fence line with the homeowner, confirm the property corners against the plat, and pull utility locates. On University Park’s tight lots this matters more than anywhere – a post hole 18 inches off can land on a sprinkler main, a pool line, or a gas service. Locates take a few days to come back, so we schedule them the moment the estimate is signed.
Day 1, afternoon: demolition and prep. If there’s an old fence, we tear it out and haul it off. This is the stage where the homeowner decides whether to reuse existing posts (rarely worth it) or start fresh. We also decide gate placement and swing direction now, because moving a gate after the concrete sets means cutting out posts.
Day 2: set the posts. Line posts go in at 8- to 10-foot spacing, terminals and corners get braced, and everything gets set in concrete – we use Quikrete fast-setting mix in most soil conditions. The posts sit overnight. The homeowner decides at this point whether they want a top rail through the whole run, which adds material and stiffness, or just at the gates and corners.
Day 3: stretch fabric and hang gates. We unroll the fabric, stretch it with a come-along until it’s tight and even, tie it off to the line posts, and hang the gates. Gate hardware is where cheap jobs show – a gate that sags in month two was undersized at the frame. We check every gate swing before we pull out.
Final walkthrough. We walk the whole fence with the homeowner, check tension, gate clearance and post plumb, and leave the site clean. Any issue found at the walkthrough gets corrected then, and the install is covered under our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Make Before We Start
- Height: 4 ft vs 6 ft. A 4-foot fence is fine for a low visual boundary and costs less in material and labor. A 6-foot fence is the typical residential pick in University Park – it reads as a real boundary and holds up better to dogs and kids. 6-foot is also where the price starts moving, roughly 15 to 25 percent more in material.
- Wire gauge. Standard residential fabric is 11.5 gauge. It’s fine and it’s what most jobs use. 9 gauge is heavier and resists denting from a ball or a dog much better – worth the upcharge on a fence that runs next to a yard with kids or pets.
- Coating and vinyl color. Galvanized is the cheapest and lasts, but it’s silver. A vinyl-coated finish in black or green costs more and looks cleaner against brick and landscaping. Vinyl coating also helps in our climate where galvanized fabric can show weathering faster in full sun.
- Gates. Walk gates, double drive gates, and self-closing hardware for pool-adjacent runs. Decide gate width before posts go in. A double gate at 10 to 12 feet is common for a side yard that needs a mower or trailer access.
- Top rail. A full top rail adds stiffness and keeps the top edge from waving. It’s an upgrade, not a default.
- Concrete mix. We use bagged Quikrete or Sakrete for post setting in most conditions – it’s predictable, and the mix is a spec you can ask about rather than a mystery.
What a Chain Link Fence Costs in University Park, TX
Residential chain link fence in University Park runs $3,500 to $9,000, with the bulk of jobs between $4,500 and $7,000. That gets you a 4- or 6-foot galvanized or vinyl-coated fence with posts set in concrete and gates installed. Here’s the table we use to build a written estimate.
| Line item | Typical range |
|---|---|
| Fence install, 100-180 LF, 4-6 ft | $3,500 – $7,500 |
| Heavier 9-gauge fabric upgrade | +$300 – $900 |
| Vinyl-coated finish | +$400 – $1,200 |
| Walk gate | $250 – $650 each |
| Double drive gate | $700 – $1,800 |
| Old fence tear-out and haul-off | $300 – $800 |
What pushes a job to the high end: length of the run, a lot with mature live oaks whose roots slow digging, grade changes along the line, a double gate, and any tree-root conflict that forces post relocation. What keeps it low: a clean straight run, no tear-out, and a standard 6-foot galvanized fence.
What’s included in a written estimate: labor, fabric, posts, top rail where specified, gates and hardware, concrete, tear-out and haul-off, and cleanup. What typically isn’t: fence staining, landscaping repair, and tree removal if a root ball is in the way – those get priced separately and called out before we set a post. The number you see is the number you pay, and it’s covered by our 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat University Park Lots Do to a Chain Link Fence Job
University Park is a built-out, landlocked Park Cities enclave in 75225, and that fact drives almost every fencing decision here. There’s essentially no vacant land – nearly every project is a rebuild or a major remodel on a lot that already has a house. Lots run narrow, many blocks have alleys, and mature live oak canopies hang over most side yards. That means staging and access become as decisive as the build itself: a crew can’t just back a trailer up to the line the way they can on a suburban lot, and every post hole near a mature oak has to be located so the root system stays intact.
The housing stock is 1920s to 1950s brick and frame cottages, many already scraped and replaced with large new custom homes. On the original cottages, our fences often run past old pier-and-beam foundations and original cast-iron plumbing that come up in the yard – which is why the utility locate and a walk of the line with the homeowner happen first. Add expansive black-clay soil and heavy spring storms, and post depth and concrete mix are not details to shortcut. When the fence is part of a full Fence Installation in University Park, we sequence the chain link last so it doesn’t get clipped by a crew working the same side yard – and if you’re already thinking about Concrete Driveways & Concrete Work in University Park or Asphalt Driveways & Resurfacing in University Park, we plan staging around it. If you want to see the wider scope, start with our Fence Installation service, or read more about how we work across University Park.
Serving University Park, TX – Our Local Coverage Area
We serve University Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in University Park
Most chain link fence jobs take one to three days on site once materials are in, and the utility locate adds a few days before that. A simple 100-foot run with no tear-out is often a single-day install. A 180-foot run with a double gate and an old fence to remove usually runs three days. Call (844) 797-4808 and we’ll give you a real timeline, not a range.
It depends on height, location on the lot, and where the property line sits. Fences over a certain height, or in a front or corner side yard, often trigger a permit; a simple rear-yard residential fence may not. Because University Park’s lots are tight and every property sits close to a neighbor, we confirm the requirement and the setback before we dig. We pull any required permits and handle the inspection. Call us and we’ll tell you exactly what your property needs.
Yes, in most cases – that’s what the utility locate and the on-site line walk are for. We mark the run, locate the sprinkler and irrigation lines, and route post holes to miss them. If a sprinkler head or line is in the way, we relocate or repair the section and tell you before the concrete goes in. Call (844) 797-4808 and we’ll walk through your yard first.
Most residential chain link fence jobs run $3,500 to $9,000, with the typical job landing between $4,500 and $7,000. Length, height, gauge, coating, gate count and tear-out move the number. Call (844) 797-4808 for an exact written quote – the estimate is free.
Every install is covered by our 730-Day Done Right Promise – if it isn’t done right, we make it right, for two full years. That covers workmanship, post setting, gate alignment and tension. Material defects are handled through the manufacturer. Call us with the issue and we’ll be back out to look at it.
Get a Free Chain Link Fence Estimate in University Park
If you’re ready to price a chain link fence in University Park, call (844) 797-4808. We’ll ask about your lot, the length you’re fencing, and whether there’s an old fence to tear out – then set a free on-site estimate where we walk the line with you and put the exact number in writing. Calls are answered by a live person, 24/7, and every install is backed by our 730-Day Done Right Promise.
Written by the team at Groundwork Construction Co.