Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Trusted Fence Installation for Dallas Homeowners
A failing fence in Dallas rarely fails quietly. Posts rot at the soil line from our shrink-swell clay, cedar pickets cup and split through a summer of 100-degree days, and one strong north wind off the prairie finishes the job. If you’re pricing Fence Installation in Dallas, a typical full yard runs $3,500 – $9,000 depending on material, linear footage, and gate count, and we put that number in writing before anyone digs a hole.

Our technicians have up to 12 years of experience setting posts in North Texas ground, and they’ll tell you straight which material holds up in your specific block. Every job is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. Calls are answered by a live person 24/7, so you’re not leaving a message and hoping. Call (844) 797-4808 to schedule your free estimate.
What Our Fence Installation Service Includes
We install and repair the full range of residential and light commercial fencing across Dallas. Here’s what each type actually means for your property.
Wood Fence
Cedar and treated-pine privacy fencing is still the standard across Dallas, and for good reason: it’s repairable, it looks right on a 1950s ranch in Casa Linda and a new build in Lake Highlands alike, and you can replace a section without touching the rest. You need wood when you want height, privacy, and a natural look, or when HOA rules call for a specific board style. We set posts below the active soil zone with proper gravel and concrete so they don’t heave when the clay moves, and we build gates with a diagonal brace and a metal frame so they don’t sag by year two.
Chain Link Fence
Chain link does the job when security and budget matter more than looks: side yards, dog runs, rental properties, and commercial perimeters. You need it when you want a durable barrier at the lowest cost per foot. We set galvanized or vinyl-coated posts to true line and grade, tension the fabric properly so it doesn’t sag at the bottom rail, and hang gates that close with one hand.
Vinyl Fence
Vinyl fencing in Dallas runs $3,500 – $9,000 for a typical yard and gives you a privacy wall that never needs staining, painting, or replacing rotted pickets. It’s the right call for homeowners tired of annual maintenance, especially on west-facing runs that take the worst of the afternoon sun. We use UV-stabilized panels rated for Texas heat, set them on reinforced posts to handle wind load, and leave proper expansion gaps so panels don’t buckle in July.
Aluminum Fence
Aluminum gives you the look of wrought iron at a lighter weight, with a powder-coated finish that won’t rust through our humidity. It’s the common choice for pool enclosures, front-yard decorative runs, and any place you want a barrier that reads as an accent rather than a wall. We set aluminum posts with the correct footings for your soil and rack the panels to follow grade so the top rail stays parallel to the ground instead of stair-stepping.
Iron Fence
Iron fencing is the heavy-duty option: ornamental steel and iron for estate frontage, security perimeters, and homes in Highland Park and University Park where curb appeal carries real value. You need it when you want maximum durability and a finish that holds for decades. We weld or bolt panels to spec, prime and coat for rust resistance, and set posts deep enough to resist the wind loads a solid iron run creates.
Fence Repair
Not every fence needs replacing. Leaning posts, a blown-out gate, storm-snapped pickets, and rotten bottom rails are all fixable, and repairing saves real money when the framing is still sound. We assess the structure first, tell you honestly whether a repair will hold or whether you’re throwing money at a fence that’s done, and match new material to what’s already there. If you’re in University Park and your fence has to match a historic or HOA standard, we’ll confirm the spec before we start.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Brands We Service for Fence Installation
Fence materials vary widely in how they age, and knowing the difference is part of the job. CGI products show up on a lot of Dallas runs, and we know exactly where their panels and hardware tend to loosen first after a few seasons of clay movement. CWS fencing components are common on residential privacy installs, and we’re familiar with how their panels handle our wind exposure and how the fasteners hold up.
We also work with ES Windows and ECO Window Systems on the exterior side of projects where fencing ties into a screened enclosure or window-adjacent privacy run, coordinating the fence line so it doesn’t interfere with the opening or the drainage. Whether your material is from one of these brands or any other make, we can help. We match new work to what’s already standing and tell you when a brand’s panel simply isn’t the right fit for a Texas-facing run.
Signs You Need Fence Installation Right Now
- Posts leaning or wobbly at the base. When a post moves in the ground, the soil around it has failed or the footing was never deep enough for our clay. One or two is a repair; a whole run leaning the same direction means the fence is telling you to rebuild.
- Rot at the bottom rail or post base. Wood wicks moisture up from the ground, and by the time you see soft wood at the base, the structural connection is usually gone. That’s a safety issue, not just a cosmetic one.
- Gates that drag, sag, or won’t latch. A gate that won’t close is a gate that’s failing at the hinge or the frame. It’s a quick fix early and a full gate rebuild later, and it’s the first thing anyone notices walking up to your house.
- Storm or wind damage with missing panels. North Texas straight-line winds and hail take out pickets and bend top rails. Left open, a damaged section puts extra load on every post beside it, so the problem spreads.
- Pickets cupping, splitting, or bowing out of line. Sun and moisture cycling warp untreated or thin wood, and once pickets cup, the fence loses privacy and looks tired. On a long run, that’s the point where replacement beats patching.
Our Fence Installation Process – Step by Step
- 1
Free on-site estimate and layout. We walk the property line with you, measure linear footage, mark gate locations, and check for utility conflicts before anyone commits to a number. You get upfront pricing, no surprises, in a written line-item quote.
- 2
Material selection and permit check. We talk through wood, vinyl, aluminum, iron, and chain link against your budget and HOA rules. Where Dallas or your city requires a permit or an HOA approval for height and setback, we flag it up front so there are no surprises after the deposit.
- 3
Site prep and post setting. We pull old fencing and concrete where needed, set string lines for true line and grade, and dig each post hole to depth based on soil and wind load. Posts go in with gravel and concrete, plumbed and braced, and we let them cure before hanging anything on them.
- 4
Panel and gate installation. Rails, pickets, and panels go up square, with consistent spacing and hardware rated for exterior use. Gates are framed and braced so they swing clean and latch without a fight, and we check every hinge and latch before we call it done.
- 5
Final walkthrough and cleanup. We walk the finished fence with you, check every post and gate, haul off all debris, and hand over your written warranty. Your work is covered by the 730-Day Done Right Promise, and if something isn’t right, we come back and make it right.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Fence Installation Cost in Dallas?
Fence installation in Dallas typically runs $3,500 – $9,000 for a standard residential yard, with the final number driven by material, linear footage, terrain, and how many gates you want. A typical vinyl privacy fence lands in that $3,500 – $9,000 band. Aluminum fencing generally runs $4,000 – $10,000. A basic chain link run comes in lower per foot, while ornamental iron sits at the top of the range for the same footage.

What moves the price: linear footage (obviously), material choice, post count, gate size and hardware, tearing out and disposing of the old fence, and whether your property line runs over roots, slope, or old concrete. Corner lots and double-gate driveway entrances cost more because there’s more fence and heavier hardware. What keeps you from overpaying is a written line-item quote: you see footage, material, gates, and labor separately, so you can compare bids on the same footing instead of guessing why one came in $2,000 higher.
Every free estimate from Groundwork Construction Co. of Dallas includes the full scope in writing, and our pricing is fixed with no change orders on the agreed work. If your project runs over $10,000, you also get $1,000 off, and 0% financing for 18 months is available. Call (844) 797-4808 for an exact quote on your Dallas fence, free, with no obligation.
Fence Installation Near Dallas – Our Service Area
We install fencing across Dallas and the surrounding communities, including Highland Park, University Park, Farmers Branch, Addison, Irving, Carrollton, Grand Prairie, Duncanville, DeSoto, Lancaster, and Glenn Heights. Typical scheduling runs within a few days of your estimate, weather permitting, and most residential runs are completed in one to two days once we’re on site. If you’re not sure whether your address falls in our coverage, call and we’ll tell you straight.
Serving Dallas, TX – Our Local Coverage Area
We serve Dallas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Fence Installation in Dallas
Fence installation is the process of setting posts, framing, and hanging panels or pickets to create a property boundary, privacy barrier, or security enclosure. It includes layout and measuring, post footings dug to the depth your soil and wind load require, panel and gate assembly, and cleanup. At Groundwork Construction Co. of Dallas, we handle the whole scope, from material selection through final walkthrough, under a written warranty.
Most residential fences in Dallas take one to two days on site once materials arrive. A short side-yard run or replacement of a single fence line can finish in a day, while long runs with multiple gates and heavy tear-out can stretch to three. The bigger variable is scheduling and material lead time, which we confirm at your estimate so you know what to expect.
Fence installation in Dallas generally runs $3,500 – $9,000 for a typical residential yard, depending on material and footage. Vinyl and wood privacy fencing fall in that range, aluminum runs $4,000 – $10,000, and ornamental iron sits at the top. Call (844) 797-4808 for an exact quote; estimates are free and come in writing.
Yes, we install and service fencing built from CGI and CWS components, along with ES Windows and ECO Window Systems on projects where fencing ties in near windows or screened enclosures. We know how these panels and hardware hold up in our clay soil and summer heat. Call (844) 797-4808 and we’ll confirm what your project needs.
We take calls around the clock, and a live person answers 24/7, so storm damage gets triaged the same day you call. For downed fencing and safety concerns, we can talk through temporary measures over the phone and get an assessment scheduled. Call (844) 797-4808 and we’ll figure out the fastest safe path forward.
Every fence we install is covered by the 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If something we built fails within that window, we come back and make it right, no fine print games. That coverage applies to the labor and workmanship, and we detail the terms in writing at your estimate.
Clear the fence line of vehicles, patio furniture, grills, and anything fragile near the work area, and make sure we can reach the property line and any gates. If pets need to stay in, arrange a temporary spot away from the install, and let us know about irrigation lines, sprinkler heads, or buried cable along the run. We’ll also call 811 to mark utilities before we dig, so have any private lines flagged and ready.
Schedule Your Fence Installation Service in Dallas Today
Ready to get a real number on your fence? Call (844) 797-4808 and a live person will set up your free, no-obligation estimate on your schedule. You’ll get upfront pricing in writing, upfront material options, and work covered by the 730-Day Done Right Promise. Fence it right the first time, with Groundwork Construction Co., and we’ll be there when you need us.
Written by the team at Groundwork Construction Co.