Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Walk-In Showers & Shower Remodeling in Addison, TX: What It Takes and What It Costs
A walk-in shower installation in Addison typically runs $4,500 – $12,000 depending on size, tile, and glass, and a full shower overhaul within a larger bathroom project lands in the $9,000 – $28,000 range. The work usually takes 5 to 12 working days once materials are on site: demo and rough-in first, waterproofing and inspections in the middle, tile and glass at the end. Call (844) 797-4808 and we’ll walk you through what your particular shower needs before anyone touches a wall.
How We Run Walk-In Showers & Shower Remodeling, Stage by Stage
Most contractors describe this job as “demo, tile, done.” The truth lives in the days between. Here’s the actual sequence we follow, which is why our showers don’t leak two summers later.
Stage 1: Site visit and layout decision (day 0)
We measure the existing shower or tub alcove and confirm what’s behind the wall: stud spacing, drain location, supply lines. You decide the footprint here – a curbless entry, a low curb, or a linear drain running along one wall. That single choice affects the next four days of work more than any tile selection does.
Stage 2: Demo and rough-in (days 1 – 2)
We tear out the old pan, tile, and backer, then inspect for hidden water damage in the framing. If the drain needs to move, or a bench and niche are going in, this is when it happens. Your only decision at this point is where the shower valve and controls sit, since that determines how you reach into the shower from outside.
Stage 3: Waterproofing and inspection (days 3 – 4)
We install a bonded waterproofing membrane over a sloped mortar bed, seal every seam and corner, and give it a flood test before tile goes anywhere near it. This is the stage homeowners never see and the one that matters most. In Addison, the building department signs off on the plumbing rough-in before walls close up, so we schedule that inspection inside this window.
Stage 4: Tile and fixtures (days 5 – 9)
Wall tile, floor tile, niche shelves, and the bench cap go in. We set the shower valve, trim, and drain grate. You pick grout color and tile layout at the start of this stage, not the end, because layout decisions made mid-install cost you days.
Stage 5: Glass, sealant, and final walkthrough (days 10 – 12)
Tempered glass panels or a frameless door get installed, we seal the joints, and we run water through the system with you standing there. Anything that drips wrong gets fixed before we leave. That final walkthrough is also where we document the work under our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
Tile, glass, and drain configuration drive both the look and the budget. Here’s the honest version of each trade-off.
- Porcelain vs. natural stone tile: Porcelain runs less expensive, resists mold better, and needs almost no sealing. Marble and travertine look richer but stain, etch, and need resealing every year or two in a wet environment. If you want stone, budget for the upkeep honestly.
- Frameless glass vs. framed enclosure: Frameless looks cleaner and holds up longer because there’s no metal channel collecting soap scum. It also costs more and requires the tile behind it to be perfectly flat.
- Curbless vs. low-curb entry: A curbless entry is safer for aging-in-place and looks seamless, but it means reworking the subfloor and drain slope, which adds cost and days. A 4-inch curb is simpler, cheaper, and still easy to step over.
- Linear drain vs. center drain: A linear drain lets you use larger format tile with fewer grout lines and slopes in one direction. It costs more to install and takes a bit more care to clean.
- Fixture brands: Moen and Delta valve-and-trim sets are what most Addison homeowners land on – reliable cartridges, easy to source parts later. American Standard offers solid entry pricing if budget is the priority. Buy the valve for longevity, not the trim.
What Walk-In Showers & Shower Remodeling Costs in Addison, TX
For a standalone walk-in shower installation, expect $4,500 – $12,000. A shower replacement (same footprint, new tile and fixtures) runs $3,000 – $8,500. If the shower is part of a broader bathroom renovation, budget the full $9,000 – $28,000 range. Here’s what moves you up or down that scale:
- Size and layout: A 36×48 alcove is the low end; a 5×6 walk-in with a bench and niche pushes toward the top.
- Existing condition: Rotted framing or a failed pan behind the old tile adds demo and rebuild time. We won’t know until the wall opens.
- Plumbing relocation: Moving the drain or valve to a new wall adds real cost. Keeping them where they are saves you several hundred dollars.
- Material grade: Porcelain and a standard glass door sit at the bottom; full stone, frameless glass, and custom niches sit at the top.
- Permit scope: A shower that changes plumbing requires a permit through the Town of Addison building department. A tile-only refresh on the same plumbing usually doesn’t.
Your written estimate lists tile, waterproofing, fixtures, glass, labor, and permit fees line by line. It does not include structural surprises found behind the wall, and we tell you that upfront rather than after demo. Add $1,000 off any project over $10,000, plus 0% financing for 18 months if you’d rather spread the cost. Call (844) 797-4808 for a free estimate.
See the difference
Before
After
Before
After
Before
AfterWhat Addison Specifically Does to This Job
Addison (ZIP 75001) is an almost entirely built-out commercial and multifamily enclave, which changes who actually hires us for shower work here. Most of our Addison calls come from apartment repositioning and multifamily rehab rather than single-family homes, and those jobs come with constraints a suburban house doesn’t: shared parking, tight staging, and late-hours noise limits that push demo into daylight hours only. Everything still permits through the Town of Addison building department.
Along Belt Line Road and Addison Road, projects squeeze onto shared-parking sites where you can’t block a tenant’s spot for a week. On those jobs we stage materials compactly and schedule tile work in shorter daily windows. The building stock itself is largely 1970s – 1980s multifamily and low-rise commercial, so we regularly find original mortar-bed pans and cast-iron drains that need attention once the wall opens. North Texas heat and freeze cycles also stress shower valve cartridges and exterior wall assemblies, which is why we spec valves that survive temperature swings and seal penetrations carefully.
If your Addison shower is part of a larger scope, our Bathroom Remodeling in Addison team handles the full project, and we cover the surrounding area through our Addison service page. If your exterior needs work too, homeowners often pair this with Roof Replacement & Installation in Addison or Metal Roofing in Addison while crews are already on site. For the broader remodel playbook, see our Bathroom Remodeling service overview.
Serving Addison, TX – Our Local Coverage Area
We serve Addison and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Walk-In Showers & Shower Remodeling in Addison
Most walk-in shower installs take 5 to 12 working days from demo to final walkthrough, with tile and glass being the longest stages. If plumbing moves or hidden damage turns up, add 2 – 4 days. Call (844) 797-4808 for a timeline based on your actual shower.
Yes, if the project changes plumbing, electrical, or the shower’s footprint, it needs a permit through the Town of Addison building department. A tile-only refresh on existing plumbing typically doesn’t. We pull the permit and handle the inspection scheduling on your behalf.
Yes. In most cases we keep the existing drain and valve location and convert the alcove to a walk-in without touching supply lines. That keeps the project simpler and shaves several hundred dollars off the total. Call (844) 797-4808 to confirm what your layout allows.
A standalone walk-in shower runs $4,500 – $12,000, and a shower folded into a full bathroom remodel lands in the $9,000 – $28,000 range. Tile grade, glass style, and plumbing changes drive the difference. Call (844) 797-4808 for a written itemized quote.
Every shower we install is backed by our 730-Day Done Right Promise – if something isn’t done right, we make it right. That covers workmanship on waterproofing, tile, and installation, and our technicians have up to 12 years of experience. Call (844) 797-4808 to talk through the details.
Get Your Walk-In Shower Priced in Addison
Call (844) 797-4808 to schedule a free on-site estimate for walk-in showers & shower remodeling in Addison. We measure the space, confirm what’s behind the wall, and hand you a written line-item quote with no change-order games. A live person answers around the clock, and your number is the number you pay. Estimates are free, and there’s no pressure to book the same day.
Written by the team at Groundwork Construction Co.