Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Highland Park, TX: What It Takes and What It Costs
Asphalt Driveways & Resurfacing in Highland Park, TX typically runs $3,500 – $9,000 for a full new asphalt driveway, and $250 – $700 for a reseal that extends the life of an existing one. Most full driveways take 2 – 4 days from demo to cure, with the freshly paved surface drivable after 24 – 48 hours. If your drive is cracked, heaved at the apron, or draining toward the garage, call (844) 797-4808 and we’ll inspect it in person before quoting a number.
How We Build and Resurface an Asphalt Driveway
The sequence below is what a Highland Park asphalt project actually looks like from the day we break ground to the day you park on it. Each stage has a decision point for you, so you know what’s coming and when.
1. Layout and demolition (day 1)
We set string lines and mark the grade against the town right-of-way before anything is torn out. If the existing drive is being replaced rather than overlaid, we break up the old asphalt and haul it off in a single load. On Highland Park lots, this is also when we coordinate the delivery window with the town, since mature tree canopy over the street usually rules out a full-size dump truck pulling straight in.
2. Subgrade prep and base compaction (day 1 into day 2)
Asphalt is only as good as the aggregate base underneath it. We excavate 6 – 8 inches, bring in crushed limestone base, and compact it in lifts with a plate or roller. This is the stage where expansive clay soils and old tree roots get addressed, because compaction over unstable subgrade is exactly how driveways develop the longitudinal cracks we see all over town.
3. Grading and drainage (day 2)
We set the slope so water sheds away from the garage and foundation, not toward it. You’ll sign off on the finished slope before paving. If the drive meets a low garage apron or a swale, we’ll discuss whether a drainage channel or a raised curb section belongs in the scope; that decision adds or subtracts from the job cost.
4. Paving and compaction (day 3)
Hot-mix asphalt goes down at 2 inches compacted thickness for residential driveways. Two lifts of 1.5 inches is the alternative for heavier loads or a truck turn-around. Pins and grade control keep the mat consistent. Roller compaction happens while the mix is still hot, and edge cuts finish the perimeter against the curb and house.
5. Cure and final walkthrough (day 3 to driving)
Fresh asphalt usually takes 24 hours before foot traffic and 48 hours before vehicles, though the surface keeps hardening for weeks. We walk the finished drive with you, review the seam lines, note the few low spots to expect as the mix settles, and hand off care instructions. Resurfacing follows a shorter version of this: clean, patch, and seal in a single day for most Highland Park driveways.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Resurface or Start Over? The Options You’ll Choose Between
The single biggest choice is whether you overlay the existing drive or tear it out. Here’s what each option actually gets you in Highland Park.
- Full replacement. Best answer for a driveway with a broken subgrade, crumbling base, or a grade that drains wrong. Runs $3,500 – $9,000 on a standard Highland Park lot and lasts 15 – 20 years with sealing. The trade-off is the extra demo and haul-away cost.
- Mill and overlay. Grinding off the top inch and paving fresh asphalt over a sound base. Cheaper than replacement and faster, but it only works if the base is still solid. If the subgrade is failing, an overlay will mirror the cracks within a couple of seasons.
- Resealing. A protective seal coat at $250 – $700, done every 2 – 3 years. It buys you time and slows oxidation, but it doesn’t fix structural cracks or settle a sunken apron.
- Hot-mix patch repair. Clean-and-fill for isolated ruts and potholes. Sensible when most of the drive is sound and the damage is concentrated where tires roll.
If the driveway is part of a bigger front-of-house upgrade, homeowners often roll the work into a full Driveway & Pavers in Highland Park project; ask about that in the estimate.
What Asphalt Driveways & Resurfacing Costs in Highland Park, TX
Expect $3,500 – $9,000 for a new asphalt driveway, and $250 – $700 for sealing. Here’s what pushes a Highland Park job toward the low or high end of that range.
- Square footage and slope. A long, sloped drive needs more material and more compaction. Typical Highland Park lots run modest, but some lots are long and narrow.
- Condition of the existing base. Crumbling concrete or a failed limestone base means demo and rebuild, not overlay. That’s the single biggest swing in cost.
- Drainage corrections. Regrading, adding a channel, or building a curb section against the garage adds scope.
- Access and delivery. On narrow, tree-canopied Highland Park streets, getting the paving equipment and hot-mix in sometimes needs coordination with the town. That’s a planning cost, not a pricing trick.
- Timing. Fresh asphalt needs to be poured in workable weather. Summer heat compresses the schedule, and getting on the calendar before the fall storm season is worth planning for.
Every written estimate is line-itemed: demo, base, paving, edges, cleanup. No surprise line items when work starts. We’ll also flag anything we can’t quote without seeing first, like a buried utility or a base issue under the apron.
See the difference
Before
After
Before
After
Before
AfterWhat Highland Park Homes Specifically Do to This Job
Highland Park is a nearly built-out enclave of century-old homes where construction almost always means renovation, addition, or teardown-rebuild under strict town oversight, and asphalt driveways are no exception. The Town of Highland Park runs its own permitting, design review, and lot-coverage rules, so a driveway replacement that touches the right-of-way or crosses a utility easement will usually need town approval even when it doesn’t need a Dallas permit. On the 1910s – 1930s Tudor, Colonial, and Mediterranean homes that dominate the housing stock, we routinely find a driveway that’s been patched so many times the base is more rubble than limestone. Mature pecan and live oak canopy means delivery windows and equipment access need coordination with the town, and the North Texas clay and summer storm cycle is the reason a drive that looked fine in March is heaving at the apron by June. When a homeowner wants a wider scope, that work often pairs naturally with a New Detached ADU in Highland Park.
Serving Highland Park, TX – Our Local Coverage Area
We serve Highland Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in Highland Park
A full replacement typically takes 2 – 4 days from demo to driving, plus about 24 – 48 hours of cure time before you park on it. Resurfacing or sealing is a single day for most Highland Park driveways. Call (844) 797-4808 for a schedule estimate once we’ve seen the drive.
It depends on whether the work touches the town right-of-way, an easement, or the lot-coverage calculation. Straight overlays and reseals usually don’t trigger a permit, while a replacement that changes the footprint or crosses a utility easement often does. We’ll tell you in the estimate exactly what the Town of Highland Park requires for your driveway, and we pull what’s needed.
Yes, if the base underneath is still solid. Mill and overlay works when the base isn’t failing, which saves the demo and haul-away cost. If the subgrade is broken or draining wrong, an overlay will mirror the cracks in a season or two, and replacement is the honest recommendation. Call (844) 797-4808 and we’ll check the base before quoting.
Full replacement runs $3,500 – $9,000 on a standard Highland Park lot, with the number landing at the high end when demo and base rebuild are needed. Sealing runs $250 – $700. Call (844) 797-4808 for an exact quote; estimates are free.
Every asphalt driveway we install is covered by our 730-Day Done Right Promise: if something isn’t right, we come back and make it right. That covers workmanship and material, and it applies whether you chose replacement, overlay, or seal. Our technicians have up to 12 years of experience, and the crew that quotes the job is the crew that shows up in uniform, background-checked, and answers the phone 24/7.
Get a Free Asphalt Driveway Estimate in Highland Park
If your driveway is cracking, heaving at the apron, or just worn from another North Texas summer, the next step is a look at the actual job. Call (844) 797-4808 to schedule a free on-site estimate for Asphalt Driveways & Resurfacing in Highland Park. You’ll get a written line-item quote, a realistic schedule, and straight answers on what the base will support. If the driveway is part of a larger front-yard project, our Driveway & Pavers service covers the full scope.
Written by the team at Groundwork Construction Co. of Dallas.