Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Addison, TX: What the Job Actually Looks Like
Door Installation in Addison, TX usually runs $650 to $2,800 per opening for a standard interior or exterior door, and a typical single-door swap is finished in one day; entry systems with sidelites or a full commercial tenant build-out run higher and longer. Most Addison jobs are scheduled within one to two weeks of an approved estimate. Call (844) 797-4808 to schedule a free on-site estimate and get an upfront written number before any work begins.
Key takeaways:
- Most single-door installs: one day on site.
- Entry doors with sidelites or transoms: two to three days.
- Commercial tenant finish-out doors: quoted per opening and scheduled around building hours.
- Permits are pulled where the Town of Addison requires them, and inspections are scheduled before we close out.
- Every job is backed by the 730-Day Done Right Promise.
How We Run a Door Installation, Start to Finish
Door work fails on the front end far more often than the back. The measurement, the prep and the hardware choice decide whether the door swings clean for the next twenty years. Here’s the sequence we follow on every Addison door installation.
Stage 1 – On-site measure and scope (day 1, about an hour)
We measure the rough opening, check the frame for plumb and square, and note the wall assembly behind the trim – brick veneer, stucco, or interior drywall. In Addison’s older 1970s and 1980s apartment stock, this is where we find out-of-square openings from decades of settling. You decide the door type, swing direction and finish at this stage so the order can be placed the same week.
Stage 2 – Material selection and ordering (days 2 to 10)
Most standard sizes ship in five to ten business days. Custom sizes, sidelites and premium hardware add two to four weeks. You approve the exact unit, the hardware finish and the threshold at this stage; once the order is placed, changes cost real money and add real time.
Stage 3 – Demo and prep (day 1 of the build, 2 to 4 hours)
We pull the old door and trim, inspect the framing and sill, and repair rot or water damage before anything new goes in. For exterior doors, we flash the opening properly – this is the step most rushed crews skip. Interior door swaps take two to four hours; exterior entry doors take a full day.
Stage 4 – Install, seal and hardware (same day, 3 to 6 hours)
The new door goes in, shims are set, the frame is secured, and the threshold is sealed. Locksets, deadbolts, closers and rolling-code remotes on garage or commercial openings get installed and tested here. We check the swing, the latch alignment and the weather seal before we clean up.
Stage 5 – Final walkthrough and sign-off (end of day, 30 minutes)
We walk the door with you, demonstrate the hardware, and hand over the care instructions. If a permit was required, we schedule the final inspection and confirm it passes before the job is closed out. You get the 730-Day Done Right Promise in writing at this point.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Door Installation in Addison is a decision-heavy job because the material and hardware choices drive both the price and the long-term performance. Here’s what actually comes up in this market.
- Fiberglass entry doors: The most popular choice for Addison homes and small commercial entries. They handle North Texas heat and hail well, won’t warp like wood, and accept a realistic woodgrain finish. Mid-range pricing, long life.
- Steel entry doors: The budget workhorse and the strongest security option. They hold up to forced entry better than any other material, but they dent on impact and need repainting every five to seven years.
- Solid wood doors: Best for interior doors and historic-feeling restaurant entries. Beautiful, repairable, and the most expensive to maintain in a climate that swings from 100°F summers to freeze events.
- Hollow-core vs. solid-core interior doors: Hollow-core keeps the budget down for closets and secondary rooms; solid-core is standard for bedrooms and any opening where sound isolation matters. In Addison’s dense multifamily buildings, solid-core is almost always the right call.
- Hardware systems: Standard keyed locksets are fine for interior doors. For entries and any shared commercial opening, rolling-code keypad remotes and smart locks are worth the upgrade – and worth specifying at order time, not after.
- Manufacturer choices: We source through established door and frame brands, including ES Windows for impact-rated entry systems where required, and CGI or CWS for standard residential and light commercial door packages.
See the difference
Before
After
Before
After
Before
AfterWhat Door Installation Costs in Addison, TX
Door Installation in Addison ranges from about $650 for a standard interior hollow-core door to $2,800 or more for a fiberglass entry system with sidelites and upgraded hardware. A written line-item estimate will show each piece before work starts.
| Scope | Typical Range |
|---|---|
| Interior hollow-core door, standard size | $650 – $1,100 |
| Interior solid-core door, standard size | $900 – $1,600 |
| Exterior steel entry door | $1,200 – $2,200 |
| Exterior fiberglass entry door | $1,500 – $2,600 |
| Entry door with sidelites or transom | $2,200 – $3,800 |
| Commercial tenant finish-out door and frame | Quoted per opening |
What pushes a job to the high end: custom or non-standard sizing, significant rot or framing repair at the opening, upgraded hardware (smart locks, rolling-code remotes, closers), permit and inspection requirements for commercial or structural changes, and any need to relocate electrical or low-voltage wiring near the door.
A written estimate from us includes the door unit, hardware, trim, sealants, labor, disposal and permit fees where required. It does not include structural reframing if we find hidden damage after demo – that gets quoted separately and approved by you before any work continues.
What Addison Buildings Specifically Do to This Job
Addison is ZIP 75001, and the housing stock is dominated by 1970s-1980s apartment communities, low- and mid-rise office buildings, and the dense restaurant cluster along Belt Line Road and Addison Road. Very little traditional single-family housing exists here, which means most of our door work is tenant finish-out, restaurant build-out, and apartment rehab rather than new home construction. The Town of Addison building department permits these projects, and we pull permits and pass inspections on every job that requires it.
That building stock has a specific failure mode we see regularly: door frames in 1970s apartment corridors that were set with minimal flashing, and the opening has absorbed forty years of North Texas heat cycles and freeze events. By the time the door starts sticking or the threshold starts leaking, the framing behind the trim is usually soft. We plan for that on the front end, which is why exterior door installs sometimes run into a second day. Restaurant and bar build-outs also require a sharp eye for grease interceptor and hood clearances where protected openings are involved, and late-hours noise and loading approvals that we schedule around the tenant’s operating hours. If the door installation is part of a larger envelope project, it fits naturally into our Windows & Doors in Addison work.
Serving Addison, TX – Our Local Coverage Area
We serve Addison and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Addison
A standard interior door takes about a day. An exterior entry door typically takes one full day, and door systems with sidelites or transoms run two to three days. Commercial tenant finish-out work depends on the scope and is scheduled around building hours. Call (844) 797-4808 for an exact timeline once we’ve seen the opening.
It depends on the door and the building. A like-for-like interior door swap usually does not require a permit, but any change to an exterior opening, a structural header, or commercial tenant work does, and the Town of Addison building department is the authority here. We pull the permits where required and schedule the inspections before we close out the job. Call (844) 797-4808 and we’ll tell you exactly what your project needs.
Yes, in most cases. If the existing opening is square and the framing is sound, the new door goes in without touching structure or mechanicals. We only quote structural work when demo reveals damage that can’t be avoided – and you approve it before we proceed. Call (844) 797-4808 to schedule an on-site assessment.
Interior doors run $650 to $1,600, exterior entry doors run $1,200 to $2,600, and entry systems with sidelites run up to $3,800. The variables that move the number are sizing, existing condition, hardware grade, and permit scope. Call (844) 797-4808 for a free written estimate on your specific openings.
Every door installation we do is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right, for two full years after the job is closed out. That’s one of the longest workmanship guarantees in the residential construction space, and it’s in writing. Call (844) 797-4808 to schedule your free estimate.
When you’re ready to move, we’re a phone call away: (844) 797-4808, answered by a live person 24/7. We work across Addison and the surrounding communities, and door installation is one of seven core service lines we handle as part of our Windows & Doors work. Homeowners often pair a door install with Chain Link Fence in Addison or Vinyl Fence in Addison when they’re tightening the property line at the same time. Our technicians have up to 12 years of experience, are background-checked and arrive in uniform, and your estimate is free with no-hassle upfront pricing.
Written by the team at Groundwork Construction Co.