Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Fence Repair in Irving, TX: What It Costs and How Fast It Can Be Fixed
Fence repair in Irving typically runs $350 to $2,200 for post, plank, gate and hardware fixes, while a larger partial rebuild lands in the $3,500 to $9,000 range once whole runs of fence come out. Most single-section repairs finish in a day, and a gate that’s sagged or a run that’s blown over in a storm is often back in service within two to three days of the estimate. Call (844) 797-4808 and we’ll set a free on-site estimate.
How a Fence Repair Job Actually Runs, Day by Day
Fence repair isn’t a mystery once you’ve done hundreds of them. Here’s the honest sequence, so you know what happens and when.
Stage 1: The walk and the diagnosis (30 to 45 minutes, day 1). We walk the fence line with you and find out what’s actually failing. A leaning post looks like one problem; sometimes the post is fine and the soil around it has let go. On the black-clay lots around South Irving, that matters. We check the posts by hand, look at how the panels sit in the rails, and note which sections are rot versus mechanical damage versus ground movement. You decide right then whether to repair just the failing sections or rebuild the run.
Stage 2: Written estimate and scope decision (same visit). You get a line-item written estimate before we touch anything: number of posts, planks, rails, gates, hardware, and any concrete work. This is where you pick repair-only versus a partial rebuild. We’ll tell you plainly when a repair is throwing money at a fence that won’t hold – and when it’s the smart move.
Stage 3: Demo and prep (2 to 4 hours for a typical repair). Failing planks come off, the bad posts get pulled (or dug out if the concrete footing has failed), and we clean up the ground where the new post will go. If the old footing was set in the clay without proper depth, it gets replaced, not reused.
Stage 4: New posts, rails and planks (half a day to two days). Posts go in first, set in concrete and left to cure the right amount of time before rails are hung. Planks and rails are installed next, then the gate is hung and adjusted. On a gate repair, the hinge and latch hardware usually gets replaced at the same time – old hardware is where a lot of sag comes from.
Stage 5: Walkthrough and cleanup (30 to 60 minutes). We walk the fence with you, swing the gate, check the latches, and leave the site clean. If it’s a repair covered by a new build or rebuild, that’s when the inspection sign-off happens.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Repair Options You’ll Actually Choose Between
Every fence repair in Irving comes down to a few real choices. Here’s the honest trade-off on each.
- Repair versus partial rebuild: A repair keeps existing posts and rails and replaces only what’s failed. Cheaper, faster, but only worth it when most of the structure is still sound. A partial rebuild replaces a whole run and costs more up front but stops the domino effect.
- Post replacement with proper footings: The biggest quality jump in any fence repair. Posts set in a properly sized concrete footing hold for years; posts set shallow will lean again after a couple of wet-dry cycles. On the older clay lots in South and central Irving, this is the fix that decides whether the repair lasts.
- Wood plank grades: Cedar holds up better than pine and costs more; pressure-treated pine is the practical choice for fence repair where you’re matching existing panels. On a rebuild, cedar or composite is worth the step up if you plan to stay put.
- Gate hardware: Basic hinges and latches versus self-closing and heavy-duty hardware. On a gate that sees daily use, the upgrade pays for itself in fewer repairs.
- Composite or vinyl panels on a rebuild: If you’re replacing a whole run, composite and vinyl products (Brands like CGI and ECO Window Systems make lines worth seeing) skip staining and rot, but cost more up front and require the right post system.
What Fence Repair Costs in Irving, TX
Fence repair in Irving runs $350 to $2,200 for most repairs, with partial rebuilds landing at $3,500 to $9,000. Here’s what pushes a job toward the low or high end:
| Repair Type | Typical Range |
|---|---|
| Plank or rail repair (small section) | $350 – $900 |
| Gate repair and re-hang | $450 – $1,200 |
| Post replacement with new footing | $500 – $1,500 per post |
| Multiple post replacements / larger repair | $1,200 – $2,200 |
| Partial rebuild of a full run | $3,500 – $9,000 |
The five variables that move the number: length and number of failing sections (one span versus a 100-foot run), condition of the existing posts and footings (a failed footing adds concrete work), material grade (matching cedar to pine, or switching to composite), gate hardware and size, and access (a fence line hemmed in by landscaping or a pool takes longer). Your written estimate spells out what’s included, line by line: materials, labor, concrete, haul-off and any permit. What typically isn’t included: replacing landscaping trampled during the job, painting or staining after a repair, and any work uncovered once we open up a section.
See the difference
Before
After
Before
After
Before
AfterWhat Irving Homes Specifically Do to Fence Repair Jobs
Irving is really two construction markets stitched together, and that split runs straight through fence repair. On the mid-century core around old downtown, the Hospital District and South Irving (ZIPs 75060 and 75061), the housing stock is 1950s-to-1970s brick-veneer ranches and small tract homes, many on shallow footings. Those original fences and gate posts are often decades old and set in the black clay that swells and shrinks with every wet-dry cycle. That’s why the failures we see most here aren’t wind – they’re leaning posts and sagging gates that let go slowly over a summer. Over on the Las Colinas and Valley Ranch side (75038 and 75039), the housing is 1980s-to-2000s subdivision product mixed with high-rise and hospitality construction tied to DFW and the Irving Convention Center. There, fence repairs tend to be more about wind and mechanical damage than soil movement. Same city, two different repair patterns. That’s also why our crew schedule shifts: we’re often doing small-footprint repairs in the South Irving core on the same week we’re working a longer rebuild in Valley Ranch. If you’re planning a replacement rather than a repair, see our Fence Installation in Irving page – and if the back fence repair is part of a bigger yard or structure project, homeowners often pair this with Garage Conversion ADU in Irving work while trades are already on site.
Serving Irving, TX – Our Local Coverage Area
We serve Irving and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions: Fence Repair in Irving
Most fence repairs in Irving finish in a day, and larger partial rebuilds take two to four days. A single gate re-hang or a small plank repair is usually done before we leave. A partial rebuild with new posts needs the concrete to set before rails go on, which is where the extra days come from. Call (844) 797-4808 and we’ll give you a realistic timeline at the estimate.
Repairing an existing fence usually doesn’t require a permit, but replacing posts, changing fence height, or rebuilding large sections can trigger one – and if the fence is on a property line, fence height and placement are governed by Irving’s local rules. Whether a permit is needed depends on what’s being changed, not just what’s being fixed. We check the requirement as part of the free estimate and pull what’s needed.
Yes, in most cases – one post can be reset or replaced without touching the rest of the run. The catch is the footing: if the original post was set shallow in the clay, just re-setting it will lean again. We replace the footing, not just the post, so the repair holds. Call (844) 797-4808 and we’ll tell you whether a post-only fix is realistic or a partial rebuild makes more sense.
Most fence repairs in Irving cost $350 to $2,200, and partial rebuilds of a full run land at $3,500 to $9,000. The number depends on how many sections are failing, post and footing condition, material grade, and gate hardware. A written line-item estimate tells you exactly where the money goes. Call (844) 797-4808 for an exact quote – estimates are free.
All our fence repair work is backed by our 730-Day Done Right Promise – if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in the residential construction space. New posts and footings are the work most likely to need a comeback, and that’s exactly the work the promise covers. Call (844) 797-4808 to schedule your free estimate.
Get a Free Fence Repair Estimate in Irving
A leaning post, a sagging gate or a run that’s finally given up – none of those need to wait. Call (844) 797-4808 and we’ll set a free on-site estimate for fence repair in Irving. On the call you’ll talk to a live person, get a walk-through scheduled, and receive a written line-item quote before any work starts. If you’re weighing a full replacement, our Fence Installation service covers that too.
Written by the team at Groundwork Construction Co.