Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Farmers Branch, TX: What It Takes and What It Costs
Asphalt Driveways & Resurfacing in Farmers Branch typically runs $3,500 to $9,000 for a full new asphalt drive, and $250 to $700 for a seal-and-resurface job on a drive that’s still structurally sound. Most residential drives here are finished in one to two days, with a 24 to 48 hour cure before you park on them. The number that decides which end you land on is simple: is the base still good, or does it have to come out? Call (844) 797-4808 and we’ll tell you straight after an on-site look.
How we build an asphalt driveway in Farmers Branch, stage by stage
Asphalt work rewards patience and punishes shortcuts. Here’s the actual sequence, with what you’re deciding at each point.
Stage 1: Site visit and base evaluation (30 to 45 minutes)
We walk the drive, probe the base, look at how water leaves the property, and check where the drive meets the garage apron and the street. On older Farmers Branch properties, this is where we find the difference between a resurface candidate and a tear-out. You decide nothing yet. We just measure and photograph.
Stage 2: Demolition and grading (half a day to a full day)
If the old surface is failing, we break it out and haul it off. If we’re resurfacing, we clean and mill the edges so the new lift ties in correctly. Subgrade gets graded to a minimum 2% slope away from the garage and structure. On the Blackland Prairie clay under Farmers Branch, that grading matters more than most homeowners realize: water that pools on the drive will find its way under it. You approve the slope and drainage direction at the end of this stage.
Stage 3: Base prep and compaction (half a day)
We lay and compact crushed stone base in lifts, typically 4 to 6 inches for a residential drive, more where the subgrade is soft. A plate compactor brings it to density. This is the stage that decides whether your asphalt lasts 8 years or 25. You don’t have a decision here, but it’s worth being around to see it done.
Stage 4: Asphalt placement and rolling (a few hours)
Hot-mix asphalt goes down at 2 to 3 inches compacted for a residential drive, then gets rolled while it’s still workable. Edges get hand-tamped. You’ll want to stay off it. Foot traffic is fine after a few hours, vehicles after 24 to 48 depending on weather.
Stage 5: Cleanup and cure schedule (same day)
We sweep, pull the forms, and leave you a written cure timeline. First seal coat is usually scheduled 6 to 12 months out, once the asphalt has fully cured and any minor settling has finished. Your only decision at the end is whether to book that first seal now or later.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between on a Farmers Branch driveway
Asphalt isn’t one thing. Here’s what actually varies, and who each choice suits:
- Hot-mix asphalt over new base vs. overlay over existing: A full build costs more but resets the clock on the whole drive. An overlay is cheaper and faster, but only works if the base is solid. If we can push a probe through the base with a screwdriver, overlay is a waste of money.
- 2-inch vs. 3-inch compacted thickness: 2 inches is fine for a standard passenger-car driveway. 3 inches suits a wider drive, a heavier vehicle, or a spot where a trailer or work truck parks. The trade-off is roughly 15 to 25% more on the paving line item.
- Seal coat frequency: A driveway sealed every 2 to 3 years will outlast one sealed every 5 to 6 by a wide margin. The 250 to 700 range for a seal job is cheap insurance against oxidation and sun cracking.
- Apron and edge treatment: The transition at the street and the garage is where most residential asphalt fails first. A proper apron detail adds cost but prevents the raveling you see on 30-year-old drives.
If the driveway is part of a larger outdoor project, our Driveway & Pavers in Farmers Branch page covers the wider scope, and homeowners often pair a new asphalt drive with a New Detached ADU in Farmers Branch when they’re adding a structure that needs its own access.
What Asphalt Driveways & Resurfacing costs in Farmers Branch, TX
Plan on $3,500 to $9,000 for a new asphalt driveway, or $250 to $700 for a resurface and seal on a drive with a solid base. Those are the real ranges for a standard residential drive in Farmers Branch, not a teaser number.
| Line item | Typical Farmers Branch range |
|---|---|
| Asphalt driveway paving (new) | $3,500 – $9,000 |
| Driveway sealing / resurfacing | $250 – $700 |
| Full driveway replacement | $5,000 – $14,000 |
| Concrete driveway (for comparison) | $4,500 – $12,000 |
| Paver driveway (for comparison) | $7,000 – $18,000 |
What moves you toward the high end: a long or wide drive (typical of the older ranch lots here), a base that has to be replaced, poor drainage that needs correction, and any root or utility conflict under the drive. What keeps you low: a straightforward resurface on a short drive with a sound base and no regrading.
A written estimate from us lists base depth, asphalt thickness, square footage, haul-off, and drainage work as separate lines. What isn’t included, unless we note it: utility relocation, driveway aprons damaged by a third party, and city permit fees if one is required. No change orders once the number is agreed. Our Driveway & Pavers service covers the broader category if you’re comparing materials side by side.
See the difference
Before
After
Before
After
Before
AfterWhat Farmers Branch homes specifically do to this job
Farmers Branch is a small, fully built-out inner-ring Dallas suburb in ZIP 75234, and that shapes this work more than anything else. There’s almost no new residential land here, so what we’re resurfacing or replacing is almost always the drive of a mid-century ranch or a post-war cottage built somewhere between the 1950s and 1970s. The southern edge near the Dallas line blends into Brook Hollow and Marsh Lane, and those older drives have usually outlived their original base by a decade or more.
The Blackland Prairie clay here is the other factor. It swells in wet springs and shrinks in drought, and that movement telegraphs straight up through a thin asphalt drive. We regularly see spider cracking and edge settlement on drives near Valley View and the I-35E corridor where the base was laid over clay with no stone lift at all. The city also enforces permits and code on older properties, so if your drive ties into a garage foundation that needs evaluation, that conversation comes before paving.
We work throughout Farmers Branch and the surrounding communities, and homeowners often pair this with a Junior ADU & Interior Conversion in Farmers Branch when they’re converting a garage and adding vehicle access elsewhere on the lot.
Serving Farmers Branch, TX – Our Local Coverage Area
We serve Farmers Branch and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Asphalt Driveways & Resurfacing in Farmers Branch
A standard residential asphalt driveway takes one to two days of actual work, plus 24 to 48 hours of cure before you park on it. A resurface-and-seal job is often finished in a single day. Call (844) 797-4808 for a timeline specific to your drive.
Resurfacing an existing drive in place usually doesn’t require a permit, but a new drive, a widened drive, or anything that changes the curb cut or stormwater flow can. We’ll tell you at the estimate whether your project triggers a permit, and that scope is written into the number so there are no surprises later.
Yes, if the base is sound and the cracking is surface-level. If the base has failed or there’s structural cracking under the surface, an overlay will crack through in a year or two. We test the base on-site before quoting, so the answer is never a guess.
Asphalt is the least expensive of the three, at $3,500 to $9,000 versus $4,500 to $12,000 for concrete and $7,000 to $18,000 for pavers, and it’s the easiest to repair. The trade-off is that it needs a seal coat every few years and has a shorter lifespan than pavers. Call (844) 797-4808 to talk through which one fits your lot and budget.
Every project is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. Our technicians have up to 12 years of experience, and all are background-checked and arrive in uniform. The number you see on the estimate is the number you pay.
Get a free estimate for your Farmers Branch driveway
Call (844) 797-4808 to schedule a free on-site estimate for Asphalt Driveways & Resurfacing in Farmers Branch. We’ll walk the drive with you, probe the base, and hand you a written line-item quote the same visit. Calls are answered by a live person, 24/7. Financing at 0% for 18 months is available, and projects over $10,000 get $1,000 off.
Written by the team at Groundwork Construction Co.