Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Grand Prairie, TX: What It Costs and How It’s Built
A chain link fence in Grand Prairie typically runs $3,500 to $9,000 for a standard residential yard, and most jobs are finished in one to three days once we have your layout and gate decisions locked in. The price depends on linear feet, height, gauge, gate count, and how much grading the Blackland Prairie clay forces us to do before the posts go in. Call Groundwork Construction Co. at (844) 797-4808 for a free on-site estimate.
How a Chain Link Fence Goes In, Day by Day
We don’t hand you a date and disappear. Here’s the actual sequence for a typical Grand Prairie chain link job, with what you decide at each stage.
Stage 1: Layout and utility locate (day 1, morning)
Before a single post is set we walk the property line with you and mark corners, gates and any turn the fence makes to follow a grade change. Then we call in the 811 locate so nobody drives a post through a sprinkler main, a gas service, or a buried electrical drop. You confirm the layout and gate swings on the spot. This is the one stage where a five-minute change saves a torn-out post later.
Stage 2: Marking and digging (day 1, mid-morning)
We string the line, set post spacing at the standard 8- to 10-foot intervals, and dig terminal and line posts. On the flat lots this is straightforward. On the sloped infill lots or older 75050 properties we may step the fence in panels to follow the ground rather than trying to force a level line across a grade that won’t hold one. Post depth and the concrete mix matter more here than on sandier ground, and we use a measured bag mix like Quikrete or Sakrete rather than guessing at a wheelbarrow ratio.
Stage 3: Setting posts and concrete cure (day 1 into day 2)
Posts go in each hole, get plumbed, and are set in concrete. We leave them to cure overnight. You don’t have to do anything during this window, but it’s the reason a chain link install rarely finishes in a single day even on a short run. Rushing a cure is how a fence ends up leaning in two years.
Stage 4: Rails, fabric, and tensioning (day 2)
Top rail, tension bands, and the chain link fabric go up, with a stretcher pulling the mesh tight and the bottom wire tied off. Gate frames are hung and adjusted so they latch clean and swing without dragging. This is where the quality shows: a fence stretched short will sag at the bottom corner within one hot summer.
Stage 5: Walkthrough and cleanup (day 2 or 3)
We walk the full run with you, check every gate, confirm the fabric is tied down, and haul off the spoil and packaging. If the job is part of a full Fence Installation in Grand Prairie project that includes landscaping or a driveway apron, the sequencing gets planned alongside it so we’re not digging twice.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Spec Choices That Actually Change Your Fence
Chain link isn’t one product. The decisions below are the ones buyers in Grand Prairie weigh most, and each has a real trade-off.
- Gauge of wire: 11.5-gauge is the standard residential weight; 9-gauge is heavier and costs more but resists denting from a ball, a dog, or a mower better. Lighter 12.5-gauge is the cheap path that shows its age first.
- Height: 4-foot for a decorative front run, 5-foot for a general backyard boundary, 6-foot when you want more privacy or pet containment. Each foot of height adds material and post cost.
- Coating: Galvanized lasts longest against rust; vinyl-coated (black, green, or brown) looks better against landscaping and adds a few hundred dollars to the job but blends into a yard far better than bare metal.
- Post and rail: Standard 1⅝-inch line posts and 1⅜-inch top rail are typical. Heavier posts matter if you’re hanging a wide drive gate or the fence is a long unsupported span.
- Gates: Single walk gate, double drive gate, or a self-closing pet gate. Each gate adds hardware, a frame, and hinges – and they’re the first thing to check on the walkthrough.
- Footings: Concrete-set posts on the standard depth are the norm. On Grand Prairie’s clay, going a bit deeper on terminal and corner posts is cheap insurance against frost heave and soil movement.
What a Chain Link Fence Costs in Grand Prairie, TX
A residential chain link fence in Grand Prairie lands between $3,500 and $9,000 for most yards. That range covers material and labor for a typical backyard boundary. Here’s what pushes a job toward the low or high end.
- Linear feet: The single biggest lever. A 150-foot run and a 350-foot run are two different projects.
- Height and gauge: Going from 4-foot 11.5-gauge to 6-foot 9-gauge can add upward of a third to material cost.
- Gates: A drive gate with heavier posts and hardware is a meaningful line item on its own.
- Site condition: Clearing brush, removing an old fence, or grading a slope all add labor. On clay that’s been baked by a dry summer, augering posts takes longer than on soft ground.
- Coating and finish: Vinyl-coated runs sit at the top of the range; bare galvanized sits lower.
Our written estimate itemizes linear feet, gauge, height, gate count, footing depth, and any demo or grading, so the number you see is the number you pay. We also pull the required permits where the scope triggers them and pass inspection. Not in the estimate unless written in: landscaping repair around posts, moving a sprinkler line, or relocating a utility.
See the difference
Before
After
Before
After
Before
AfterWhat Grand Prairie Specifically Does to a Chain Link Job
Grand Prairie straddles the Dallas and Tarrant county line, and that one fact changes how fences here get permitted and inspected. A single city can sit inside two counties, which means the permit routing, inspection scheduling, and even the reviewing office depend on which side of the line your property falls on. We check that before we file, because a fence that clears on the Dallas-county side still has to satisfy the Tarrant-county side. The other local reality is the Blackland Prairie clay underfoot. It’s some of the most expansive soil in North Texas, and it swells and shrinks with the drought-to-deluge swings we get most springs. That movement is why we set corner and terminal posts a little deeper than the minimum and why a fence can look fine for two years and then lean after a wet season. In the older 75050 and 75051 blocks near the original downtown core, the mid-century ranches and small post-war homes often already have a fence line that’s been reset once, so we measure the actual grade rather than assuming the lot is flat. On the newer 1990s-and-later subdivisions out toward 75054, it’s usually a clean install over a graded lot. Either way, a fence is only as good as the posts, and the posts are only as good as the ground under them.
Serving Grand Prairie, TX – Our Local Coverage Area
We serve Grand Prairie and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Chain Link Fence in Grand Prairie
Most residential chain link fences are finished in one to three days, depending on run length and whether you’re adding gates. The concrete cure overnight is built into that timeline; rushing it is how a fence fails early. Call (844) 797-4808 to get a firm date on your specific layout.
Permit needs depend on fence height, location, and which county your property sits in, and the rules can differ across the Dallas/Tarrant county line. We check the requirement for your address at the estimate stage and pull and pass the permit where it applies, so you’re not the one chasing the inspector. Call us to find out what your property requires.
A proper install avoids buried lines by calling in the 811 utility locate before any post goes down, and we mark your irrigation on top of that during the layout walk. If a sprinkler head or line is in the post path, we flag it before digging and let you decide how to handle it. Call (844) 797-4808 to set up a layout walk.
Plan on $3,500 to $9,000 for a typical residential job, with larger runs, taller fences, and drive gates pushing toward the high end. Our written estimate is itemized and fixed, so the number you see is the number you pay, with no change orders unless you add scope. Call (844) 797-4808 for an exact quote; the on-site estimate is free.
Every chain link fence we install is covered by the 730-Day Done Right Promise, one of the longest workmanship guarantees in the residential construction space. If something’s not done right, we make it right. Call (844) 797-4808 and we’ll walk you through what the promise covers on your job.
Get a Free Chain Link Fence Estimate in Grand Prairie
Call (844) 797-4808 for a free on-site estimate on your chain link fence in Grand Prairie. A live person answers, every time, day or night. We’ll walk the property line with you, talk through gauge, height, and gates, and hand you a written itemized price that stays put. If you’re fencing the yard as part of a bigger project, homeowners often pair this with a Concrete Driveways & Concrete Work in Grand Prairie project to finish the front, and the two get scheduled together. See everything we do across Grand Prairie and our Fence Installation service for the full scope. For a resurfaced or new Asphalt Driveways & Resurfacing in Grand Prairie job, we’ll coordinate that too.
Written by the team at Groundwork Construction Co.