Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Grand Prairie, TX
Concrete driveways and concrete work in Grand Prairie typically cost $4,500 – $12,000 for a new standard driveway pour, with a full replacement running $5,000 – $14,000 when the old slab has to come out first. A straightforward 400 – 600 sq ft driveway is usually a 2 – 3 day job once the crew starts, but the slab needs 7 days before you drive on it and about 28 days to reach full cure. Call (844) 797-4808 for a free on-site estimate and a written line-item quote.
How the work actually runs, start to finish
Concrete is one of the few trades where the wrong sequence shows up two years later as a crack. Here’s what our process looks like from the first walkthrough to the day you park on it.
Stage 1: Site visit and layout (day of estimate)
We measure the driveway, check where water currently runs, and look at the existing subgrade. You decide the width, the expansion-joint pattern, whether you want a broom, salt-and-pepper, or exposed-aggregate finish, and where the control joints land. We also confirm whether the slope off the garage apron has to be recut, which is one of the most common fixes on older slabs. You get a written line-item quote before anyone touches a shovel.
Stage 2: Demo and haul-off (day 1, 4 – 8 hours)
For a replacement, we break out the old concrete, cut the joints clean at the apron, and haul everything away. That’s typically two loads for a standard residential driveway. You decide whether the old apron lip stays or gets ground down, and whether the crew brings grade up with select fill or you’re keeping the existing base. On a fresh install, stage 2 is mostly grading and compaction, which runs 2 – 4 hours.
Stage 3: Forming and subgrade prep (day 1 into day 2)
Forms go up, the base is compacted in lifts, and we set the rebar or wire mesh on chairs so it sits mid-slab rather than on the dirt. This stage is where the “cheap pour” jobs cut corners, and it’s where homeowners decide whether to add a thickened edge, a drainage swale, or an expansion joint to the garage slab. Allow a full day on anything over 500 sq ft.
Stage 4: Pour and finish (day 2 or 3, morning start)
We pour early, screed, float, and apply your chosen finish while the concrete is still workable. Control joints are cut same-day on most jobs. You’ll want to be around for the finish decision, because once it’s broomed you’re not changing it. This is a 3 – 6 hour window for a residential driveway.
Stage 5: Cure and backfill (days 3 – 10)
We pull forms the next day, backfill the edges, and water-cure the slab for the first week. Foot traffic is fine after 24 – 48 hours, but keep vehicles off for 7 days. Full cure is 28 days, which matters if you’re planning to seal it later or lay anything against it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Your material and finish choices, with the honest trade-offs
- Standard 4-inch slab, broom finish – the workhorse. Around $4,500 – $8,000 for a typical Grand Prairie driveway. Broom texture grips shoes in the rain and hides tire marks, but it does pick up oil stains and it’s the least forgiving of a poor subgrade. Suits most homeowners who want a clean, functional driveway and don’t care about decorative detail.
- 6-inch slab with rebar and a thickened edge – the right call if you drive heavy trucks or an RV, or if the soil under the slab is clay-heavy and unstable. Pushes the job toward the top of the $12,000 range. Costs more up front, but the load capacity is a real difference on Grand Prairie clay.
- Exposed-aggregate finish – a textured, pebble-forward look with better slip resistance than a clean trowel finish. It also hides minor surface cracks well. The trade-off is that it’s harder to clean and the finish requires more careful timing during the pour, so it adds roughly 10 – 15% to the labor line.
- Salt-and-pepper (light sandblast) finish – a middle-ground texture that reads clean without the glossy trowel look. Easier to maintain than full exposed aggregate and it takes sealant well. A good choice if you plan to seal every few years and want the finish to hold up.
- Stamped or decorative concrete – has its own page and we won’t relitigate it here. It’s the finish to choose when the driveway is a visible design element rather than a utility surface, and it carries a meaningful premium.
The decision that matters more than finish is base: a 4-inch slab on uncompacted fill will crack no matter how good the surface looks. We spec the base to the soil, not to a default number.
What concrete driveways & concrete work costs in Grand Prairie, TX
Plan on $4,500 – $12,000 for a new concrete driveway and $5,000 – $14,000 for a full replacement in Grand Prairie. Here’s what pushes a job to the low or high end of those ranges.
- Size and thickness – a 400 sq ft driveway and a 900 sq ft driveway are not the same job. Every additional inch of thickness adds material and labor. Most single-car aprons come in near $4,500; a wide double driveway with an RV pad lands at the ceiling.
- Existing condition – demo and haul-off of a broken slab adds $800 – $2,500 depending on how thick the old concrete is and how much rebar is embedded. Old slabs from the mid-century 75050 homes can be thicker than expected.
- Base and subgrade work – if the soil under the driveway has already moved or settled, we may need to over-excavate and bring in select fill. That’s a $1,000 – $3,000 line on a clay-heavy site.
- Drainage correction – regrading so water runs away from the garage adds cost but prevents the recurring re-pour that comes from poor drainage on flat lots.
- Permit and inspection scope – some driveway projects are permitted, especially in Grand Prairie where right-of-way or drainage changes are involved. We pull the permit and pass the inspection; the fee is baked into the written estimate, not added later.
What’s included in our written estimate: demo, haul-off, base prep, rebar or mesh, formwork, pour, finish, control joints, and permit where required. What typically isn’t: landscaping restoration outside the work area, sealing (that’s a separate line item), and any utility relocation the surveyor uncovers after the fact. If something changes, you know before the change happens.
See the difference
Before
After
Before
After
Before
AfterWhat Grand Prairie homes specifically do to this job
Grand Prairie straddles the Dallas and Tarrant county line and sits on the Blackland Prairie’s expansive clay. That combination is why driveways here crack more, heave more, and need more careful base work than the same job in a sandier suburb. We see it in the mid-century homes around the old downtown core in 75050 and 75051, where original slabs are often 40-plus years old and show the longitudinal cracking that comes from wet-dry cycles on clay. Out in 75052 and 75054, the 1990s – 2010s tract subdivisions have newer slabs but frequently poor drainage at the garage apron, and the same clay underneath doesn’t forgive a lazy pour. Because a single Grand Prairie address can fall under Dallas County or Tarrant County permitting, confirming the right jurisdiction before forms go up is part of our process, not an afterthought. Call (844) 797-4808 to schedule your free estimate and we’ll sort the jurisdiction from the property records.
Serving Grand Prairie, TX – Our Local Coverage Area
We serve Grand Prairie and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Concrete Driveways & Concrete Work in Grand Prairie
A standard replacement is 2 – 3 working days from demo to pull-forms, plus 7 days before you drive on it. Smaller pours can finish in a single day. Call (844) 797-4808 for a firm timeline based on your driveway.
Most straight driveway replacements don’t need a permit, but any project touching the right-of-way, drainage, or property setback does, and the county rule depends on which side of the Dallas-Tarrant line you sit on. We pull the permit and pass the inspection when one is required, and it’s included in your written estimate.
Yes, in most cases. We protect adjacent beds and grass with plywood and haul-out paths, and restoration is only needed where the crew has to bring equipment or base material in. Call (844) 797-4808 to walk your specific layout.
New concrete driveways run $4,500 – $12,000 and replacements run $5,000 – $14,000, with the final number set by size, thickness, base condition, and finish. Call (844) 797-4808 for an exact quote – estimates are free.
Every concrete pour we complete is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That includes surface defects and workmanship issues within the guarantee period. Pricing is upfront with no change orders once the quote is signed.
Get your free concrete estimate
If your Grand Prairie driveway is cracked, sinking, or just past its useful life, call (844) 797-4808 for a free on-site estimate. We measure the slab, check the base, confirm the county and permit scope, and hand you a written line-item quote with the final number on it – no vague ranges, no surprises. Calls are answered by a live person.
Written by the team at Groundwork Construction Co.